Wiremold® Plugmold® multioutlet Systems
■INSTAll BASE SECTION ON SURFACE – Use No.8 flat head screws in pre-drilled mounting holes in base. If required, cut base to length and debur ends before mounting. Center the cover section over the mounted cut base section. Locate, mark and cut the cover ends. If any receptacle falls closer than 1 1/2" [38mm] from the end of the unit, receptacle must be cut out to allow sufficient space for the installation of end fitting (Cut a blank section of raceway cover to fit over any cut out holes). Again debur cut ends before installing.
■CONNECT WIRED SECTION To Feed (Center feed method) – Snap receptacles out of cover on both sides of feed point. See Figure A for recommended wire connector locations. If the receptacle center spacing is 12" [305mm] or greater, stagger the wire connectors between the receptacles instead of going around the receptacles (Figure A). Cut and strip (See Figure B for strip length) black, white, and green wires on harness and feed. Connect harness to feed wires with W30 and W30G Wire Connectors. Use one individual connector to splice each of the three colored wires. Use W30 Connector for black and white wires and W30G Connector for green wire. Stagger the locations of the three wire connectors to allow ample space for the wiring to be tucked into raceway section. Snap receptacles back into the holes in the cover. Ensure all wiring is pushed completely into the cover before assembling cover to base to avoid pinching the wires.
|
2000 、 2000USB 、 2000TR 、 2000TRUSB 、 2000TRUSBA |
|
|
|
|
|
User's Guide |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
09/14 |
|
|
|
|
|
40869R7 |
|
|
1.1 MB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
