MMC2001 M•CORE™ Integrated Microcontroller Product Brief
●The MMC2001 incorporates the following functional units:
■M•CORE Integer Processor
▲32-bit RISC architecture, 16-bit instructions
▲Low power, high performance
■OnCE™ Debug Module
■On-chip SRAM, 32 kbytes with battery backup supply support
■On-Chip ROM, 256 kbytes
■Interrupt Controller with support for up to 32 Interrupt sources
■External Interface Module
▲External interface with 20 address lines and 16 data lines
▲Chip select and wait state generation
▲Bus watchdog timer
■Timer/Reset Module
▲Crystal oscillator generates on-chip clock signal from a 32.768 kHz crystal
▲Time-of-day timer provides real-time event information
▲Watchdog timer resets the chip to recover from system failure
▲Reset unit provides low voltage detection and backup power switching
▲Periodic interrupt timer
■Serial Communication Port (UART)
▲Two independent UART channels
▲Asynchronous Operation
▲Baud Rate Generation
■16-bit General Purpose I/O Port with support for Keyboard Scan / Encode
■8-bit General Purpose I/O Port with support for Edge/ Level sensitive external interrupts
■Pulse Width Modulation Module
▲Six independent PWM channels
▲Pins can also be configured for general purpose I/O
■Serial Peripheral Interface (ISPI)
▲Interval-mode SPI operation
▲Efficient communication with slower serial peripherals
▲Designed for master/slave SPI operation
■DC to 33 MHz Operation
■Low Voltage — 1.8 to 3.6 Volt operation with separate input/output and core supplies
●Figure 1 is a block diagram of the MMC2001 microcontroller. The paragraphs that follow describe the functional components of the integrated control system.
|
|
Supplier and Product Introduction |
|
|
|
Please see the document for details |
|
|
|
|
|
LQFP |
|
English Chinese Chinese and English Japanese |
|
2020/03/24 |
|
|
|
MMC2001PB/D |
|
282 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.