Connecting Multiple MSC8102 Devices on a System Bus

PublishTime：2021-10-26

●This application note describes how to connect up to eight MSC8102 devices in a system, each configured differently. No additional glue logic is needed for reset configuration. In a typical multi-MSC8102 system, one MSC8102 device acts as the configuration master and all other MSC8102 devices act as configuration slaves. The configuration master reads the various configuration words from EPROM and uses them to configure itself as well as the configuration slaves.
●To configure a multiple-MSC8102 system, you must complete the following tasks:
■Connect the CNFGS, RSTCONF, and HRESET signals properly.
■Connect the 60x-compatible data bus between all MSC8102 devices.
■Configure the Hard Reset Configuration Word (HRCW) for all MSC8102 devices at the correct addresses.

Brand of Product：	NXP
Part#：	MSC8102 More Part#
Product Category：	More
Application：	More
Data Type：	Application note & Design Guide More
Safety & Environment Standards：	More
Operating Temperature：	Please see the document for details
Qualification Grade：	More
Qualification Approval：	More
Package：
Language：	English Chinese Chinese and English Japanese
Date of Creation：	2/2003
Version Number：	Rev. 0
Data Encoding：	AN2452/D
Data Size：	627 KB

Data section preview(2pages)

- The full preview is over. If you want to read the whole 8 page document,please Sign in/Register -

Download

+1 Like
Add to Favorites

Recommend

Technical Resources

More>

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Integrated Circuits