111P / 233P / 233P-1.5 SERIES Protection Relays

2021-08-17
The Littelfuse Models 111P (115 V, ¹⁄³ to 1 hp); 233P-1.5 (230 V, ¹⁄³ to 1.5 hp); and 233P (230 V, ¹⁄³ to 3 hp) protect pumps from dry-well, dead-head, jammed impeller, overvoltage/undervoltage conditions, and rapid-cycle protection whether the pressure switch is mounted before or after our unit.
A calibration adjustment allows the unit to be calibrated to your specific pumping applications, thereby reducing the possibility of false or nuisance tripping. A unique microcontroller-based voltage and current-sensing circuit constantly monitors the incoming power for fluctuations, overcurrent, and undercurrent. When an abnormality, such as loss of suction is detected, the unit deactivates its output relay and directly disconnects the pump motor. The unit then begins its user-selectable restart delay (dry-well recovery) timer. When the timer counts to zero or power is removed and reapplied, the unit reactivates its output relay and turns the pump back on.
The infrared LED communicates with a hand-held diagnostics tool called the Informer (sold separately). The Informer displays parameters including calibration points, trip points, run time and last faults.
Special considerations for pump cables larger than #10 AWG:In some cases where larger motors are installed with deep set pumps, pump cables are used that exceed the relay’s terminal size. In these conditions, a short splice of #10 AWG or #12 AWG may be a solution at the control box.
Note: All local, state and national electric codes should be followed when applying this solution.

Littelfuse

233P-1.5 SERIES233P-1.5233P SERIES233P111P111P SERIES111P-ENCL233P-ENCL233P-1.5-ENCL

More

Part#

Protection RelaysSingle-Phase Pump Monitor

More

More

Datasheet

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

042619

Rev: 2-C-042619

433 KB

- The full preview is over,the data is 2 pages -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: