EFM32 Giant Gecko Series 1 EFM32GG11 Errata
This document contains information on the errata of EFM32GG11. The latest available revision of this device is revision A. Several revision A part numbers are available at Engineering Status, which is denoted with revision code X. For the purposes of this document, revision “A/X” refers to both revision A and revision X part numbers.
For errata on older revisions, please refer to the errata history section for the device. The revision information is typically specified inor near the trace code on the device. Refer to the package marking information in the data sheet for more information.
Detailed Errata Descriptions:
●ADC_E213 – ADC KEEPINSLOWACC Mode
●ADC_E224 – ADC Warm-Up Ready Can Cause IDAC, ACMP, or CSEN to Not Function
●ADC_E225 – Using the ADC in High Accuracy Bias Mode Will Force All Analog Peripherals to High Accuracy Bias Mode
●BU_E201 — Extra Current from BUVDD to VREGVDD in BUMODE when Pulling Main Supply Low
●BU_E202 — Extra Current from DVDD to GND in BUMODE when Pulling BUVDD Low
●CUR_E203 – Occasional Extra EM0/1 Current
●CUR_E204 – Extra EM4S Current When ANASW Set to 1
●DBG_E204 – Debug Recovery with JTAG Does Not Work
●EMU_E214 – Device Erase Cannot Occur if Voltage Scaling Level is Too Low
●LCD_E201 — LCD Boost Mode Does Not Work
●RMU_E202 – External Debug Access Not Available After Watchdog or Lockup Full Reset
●RMU_E203 – AVDD Ramp Issue
●RTCC_E203 – Potential Stability Issue with RTCC Registers
●RTCC_E205 – Wrap Event Can Be Missed
●USART_E201 — USART DMA Transactions Fail with Slow Peripheral Clocks
●USB_E201 — USB PHY Short Circuit Failure
●VDAC_E201 — VDAC Output Drives All APORT Buses Simultaneously
●VDAC_E202 — PRS Outputs Not Generated when Interrupt Flag is Set
|
|
|
|
Errata |
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
July 24th, 2017 |
|
Rev. 0.2 |
|
|
|
745 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.