Keysight Infiniium UXR-Series Oscilloscopes Programmer's Guide

2021-06-16
This book is your guide to programming Infiniium oscilloscopes that have the 10.00 or greater user interface software. Supported models include: UXR-Series oscilloscopes.
In this book, Chapter 1, “What's New,” starting on page 41, describes programming command changes in the latest version of oscilloscope software.
Chapter 2, “Setting Up,” starting on page 69, describes the steps you must take before you can control the oscilloscope with remote programs.
The Keysight UXR-Series oscilloscopes command set is most closely related to version 6.20 of the Infiniium oscilloscope operating software.
The main differences between the version 6.20 programming command set for the Infiniium oscilloscopes and the 10.00 programming command set for the Infiniium UXR-Series oscilloscopes are related to:
●New OR, Burst, and Nth Edge trigger modes and new options in existing trigger modes.
●Digital channels are not supported on the UXR-Series oscilloscope models.
●GBit serial triggering is not supported on the UXR-Series oscilloscope models.
●Roll mode and equivalent time sampling modes are not supported on the UXR-Series oscilloscope models.
●Advanced trigger commands have been deprecated.

Keysight

UXR-Series

More

Part#

Oscilloscopes

More

More

User's Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

July 2020

Version 10.25.00608

39.4 MB

- The full preview is over. If you want to read the whole 1784 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: