MRF24J40 IEEE 802.15.4™ 2.4 GHz RF Transceiver
■The MRF24J40 is an IEEE 802.15.4™ Standard com-pliant 2.4 GHz RF transceiver. It integrates the PHY and MAC functionality in a single chip solution.Figure 1-1 shows a simplified block diagram of a MRF24J40 wireless node. The MRF24J40 creates alow-cost, low-power, low data rate (250 or 625 kbps) Wireless Personal Area Network (WPAN) device. TheMRF24J40 interfaces to many popular Microchip PIC® microcontrollers via a 4-wire serial SPI interface,interrupt, wake and Reset pins.
■The MRF24J40 provides hardware support for:
▲Energy Detection
▲Carrier Sense
▲Three CCA Modes
▲CSMA-CA Algorithm
▲Automatic Packet Retransmission
▲Automatic Acknowledgment
▲Independent Transmit, Beacon and GTS FIFO Buffers
▲Security Engine supports Encryption and Decryption for MAC Sublayer and Upper Layer
■These features reduce the processing load, allowingthe use of low-cost 8-bit microcontrollers.
■The MRF24J40 is compatible with Microchip's ZigBee®, MiWi™ and MiWi P2P software stacks. Each software stack is available as a free download, includ-ing source code.
Features:
■IEEE 802.15.4™ Standard Compliant RF Transceiver
■Supports ZigBee®, MiWi™, MiWi P2P and Proprietary Wireless Networking Protocols
■Simple, 4-Wire Serial Peripheral Interface (SPI)
■Integrated 20 MHz and 32.768 kHz Crystal Oscillator Circuitry
■Low-Current Consumption:
▲RX mode: 19 mA (typical)
▲TX mode: 23 mA (typical)-Sleep: 2 uA (typical)
■Small, 40-Pin Leadless QFN 6x6 mm2 Package
|
|
Datasheet |
|
|
|
Please see the document for details |
|
|
|
|
|
QFN |
|
English Chinese Chinese and English Japanese |
|
March 2021 |
|
Revision E |
|
DS30009776E |
|
1.1 MB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.