Power Electronics Device Modeling

2021-05-17
●Power Electronics Device Modeling
■Power Electronics (PE) design engineers are under strong schedule pressure to address the growing needs of power conversion, motor drivers, etc. Meanwhile, to enable smaller designs, the switching frequencies are going up into the 100s of kHz and even low MHz. While these might be modest frequencies, the voltages, and in particular, the changes in voltages versus time (dV/dt) are very large. GaN devices today are switching within 250 ps, generating harmonic content into the GHz range. Inductances as small as 0.1 nH can reshape the waveforms driving the gate, causing ringing and transient induced noise. Stray inductance in the high current path is very common, leading to large L*di/dt.
■These surges in voltage and current, along with the ringing that follows can cause circuit malfunction, and in some cases, circuit explosion. The high switching frequencies and associated harmonics lead to undesirable electromagnetic interference.

Keysight

W8536EP/ETW8537EP/ETW8538EP/ETW8598BP/BTW8598BPPD1000AB1506A

More

Part#

Power Electronics DevicePower Electronics ModelCurve Tra cerMeasurement SystemDouble Pulse Test SystemS-Parameter Measurement SystemPower Device Measurement System

More

More

Supplier and Product Introduction

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

March 23, 2018

5992-2771EN

1.8 MB

- The full preview is over. If you want to read the whole 8 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: