AN1267: Radio Frequency Physical Layer Evaluation in Bluetooth® SDK v3.x

2021-05-08
This application note provides an overview of how to perform Bluetooth-based radio frequency (RF) physical layer (PHY) evaluation with Bluetooth-enabled EFR32xG system-on-chips (SoCs)and BGM/MGM modules using Silicon Labs’software tools and dedicated firmware. A Bluetooth device’s RF parameters are validated using a protocol called Direct Test Mode (DTM). DTM is described in the Bluetooth Core Specification versions 5.x, Volume 6, Part F.
●Testing can be performed in three ways:
■Through DTM test commands issued by a host system over the SoC’s or module’s host interface.
■Through DTM test commands issued by a custom application running in the SoC or module itself. Such commands could be autonomously launched by the custom application, for example at boot or after a remote companion device writes a dedicated GATT characteristic over a Bluetooth LE connection.
■ In a special test environment supported by dedicated firmware that allows a testing device to control the test target.
With these options, customers can fully evaluate transmit and receive performance,and test the RF functionality of their development kit hardware or custom hardware.
Laboratory tests require RF test equipment, such as a spectrum analyzer and an RF signal generator, and/or a Bluetooth tester.
●KEY POINTS:
■Basics of Direct Test Mode (DTM)
■Testing with NCP Commander
■Testing with DTM 2-wire firmware
■Test examples

Silicon Labs

EFR32xG

More

Part#

system-on-chips (SoCs)modules

More

More

Application note & Design Guide

More

More

Please see the document for details

More

More

English Chinese Chinese and English Japanese

2020/12/11

Rev. 0.2

AN1267

3.8 MB

- The full preview is over. If you want to read the whole 27 page document,please Sign in/Register -
  • +1 Like
  • Add to Favorites

Recommend

All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.

Contact Us

Email: