CT-11: FPL ZERO-SEQUENCE SENSORS WITH LITTELFUSE RELAYS Technical Note
Toroidal (Type T) zero-sequence sensors manufactured by Federal Pioneer Ltd. can be used with Littelfuse Startco ground-fault and motor-protection relays. Table 1 lists compatible FPL sensors and window sizes. These sensors can be used on resistance-grounded systems and on solidly grounded systems where the maximum ground-fault current is less than 50 kA.
When using an FPL sensor with the SE-701 Ground-Fault Monitor, the CT-primary rating is 50 A. The SE-701 set-point range is 1 to 99% in 1% increments, which corresponds to 0.5 to 49.5 A in 0.5-A steps. If the ground-fault current can exceed 400 A, a voltage-clamping device must be used as shown in Fig. 1. An SE-EFVC is recommended for these applications.
When using an FPL sensor with an FPS, FPU-32, MPS, or MPU-32, the earth-fault CT-primary rating should be set to 50 A. This will provide correct earth-leakage metering information and trip levels. The set-point range is 1 to 100% in 1% increments, which corresponds to 0.5 to 50 A in 0.5-A steps. For the MPS, the set-point range is 5 to 100% in 1% increments, which corresponds to 2.5 to 50 A in 0.5-A increments.If the earth-fault current can exceed 200 A, a voltage-clamping device must be used. An SE-EFVC is recommended for these applications, as shown in Figs. 2, 3a, and 3b.
|
|
|
|
Application note & Design Guide |
|
|
|
|
Please see the document for details |
|
|
|
|
|
|
|
|
|
|
|
English Chinese Chinese and English Japanese |
|
|
2019/03/29 |
|
|
Rev: 111418 |
|
|
Pub. TN-CT11 |
|
|
324 KB |
- +1 Like
- Add to Favorites
Recommend
All reproduced articles on this site are for the purpose of conveying more information and clearly indicate the source. If media or individuals who do not want to be reproduced can contact us, which will be deleted.
Integrated Circuits
Discrete Components
Connectors & Structural Components
Assembly UnitModules & Accessories
Power Supplies & Power Modules
Electronic Materials
Instrumentation & Test Kit
Electrical Tools & Materials
Mechatronics
Processing & Customization
