Document P/N: 64-1125-01 R
Removing an
If you need to replace an op tic
• Optical Module S TM-1/
Do not remove and insert an o
its useful life.
Caution: Be sure to follow ele
Removing the Optic
Complete the followin
steps t
1. Disconnect and remove
current connections of t
Caution: After removin
t
protect the optical module.
the optic surfaces of the fib
optics may not work correc
2. Open the optical modul
3. Hold the optical mod ule
from the port.
4. Plac e the remov ed op t i
5. If you are not immediat
optical module cover in
Replacing the Optic
Complete the followin
steps t
1. Ensure that the bale cla
2. Ali
n the optical modul
clicks when it snaps int
3. Connect a fi ber opt ic ca
this time, insert a clean
Note: Th e dust co ve r k eeps th
the dust cover in a plastic ba
v A
d Replacing an Optical M
l module, order the following component:
C-3 (BDN-OPT-1000)
tical module more often than necessary as t
trostatic dischar
e protection procedures.
l Module
remove the optical module:
all interface cables from the ports, keepin
t
he cables to the ports on the line card.
e cables, insert a clean dust cover into the c
Before you plu
the cable into the new optic
er cable. If dust
ets into the optical ports of
ly.
bale clasp.
with your thumb and index fin
er and carefu
al module on an antistatic mat or in a static
ly insertin
a replacement optical module, i
o the optical module ca
e to protect it from
l Module
replace the optical module:
p is closed before you insert the optical mod
with the optical port and slide it into the por
place.
le to the optical module . If you are not conn
protective dust cover into the optical module
optical ports free from dust and other conta
r some other device to keep it clean when it
dule
is may shorten
ack of the
ble connector to
l module, clean
the module, the
ly remove it
hieldin
ba
.
sert a clean
ust and debris.
ule.
. The module
ctin
a cable at
.
minants. Store
is not in use .