OPL530, OPL531, OPL535, OPL536, OPL550,
OPL551, OPL560, OPL561, OPL562, OPL563
© TT electronics plc
Issue C 09/2016 Page 1
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.electronics.com
General Note
TT Electronics reserves the right to make changes in product specicaon without
noce or liability. All informaon is subject to TT Electronics’ own data and is
considered accurate at me of going to print.
Descripon: All components in this series include a photodiode, amplifier, voltage regulator, Schmitt trigger and
NPN output transistor on a single silicon chip. OPL560 chips also include a voltage regulator on the chip. All
devices in the series have a Photologic® chip that is encapsulated in a molded plastic side-looking package with
an integral lens (recessed integral lens for OPL535 and OPL536). This packaging provides enhanced optical
coupling, combined with mechanical protection. The hysteresis characteristics of the Schmitt trigger on each
device offers high immunity to noise on input and V
CC
.
OPL530, OPL531, OPL535 and OPL536 include a 10 K Ω pull-up resistor (R
L
) from output to V
CC
. These
components exhibit very stable performance over supply voltages ranging from 4.5 V to 16 V and a wide range of
irradiance levels. OPL550 and OPL551 devices feature TTL/LSTTL compatible logic level output which can drive
up to 8 TTL loads without additional circuitry and medium-speed data rates to 250 kBaud, with typical rise and fall
times of 25 nanoseconds. OPL560, OPL561, OPL562 and OPL563 devices feature TTL/LSTTL compatible logic
level output which can drive up to 10 TTL loads over supply voltages ranging from 4.5 V to 16 V.
OPL530, OPL531, OPL550, OPL551, OPL560, OPL561, OPL562 and OPL563 are mechanically and spectrally
matched to OP140 and OP240 LEDs. OPL535 and OPL536 are mechanically and spectrally matched to OP145
and OP245 series LEDs.
Applicaons: Non-contact reecve object sensor, Assembly line automaon, Machine automaon, Machine safety, End of travel
sensor, Door sensor
Features:
Choice of four output opons in low-cost side-looking package
Choice of two sensivity opons (OPL560/561/562/563)
High noise immunity
Direct TTL/LSTTL CMOS interface
Data rates to 250 kBaud for all except OPL560 series (200 kBaud)
Low power consumpon
Base Part Number
Package
Output Type - with Light
Input Power Range
(mW/cm
2
) [Min/Max]
- A B
OPL530, OPL530-OC
External Lens
Internal 10K - High
0.08/0.40 0.08/0.25 0.20/0.40
OPL531A, OPL531-OCA
Internal 10K - Low
OPL535A, OPL535B
Recessed
Lens
Internal 10K - High
OPL536A, OPL536-OC, OPL536-OCA
Internal 10K - Low
OPL550, OPL550A, OPL550-OC, OPL550-OCA
External Lens
Totem Pole - High 0.25/2.4 0.25/1.4
N/A
OPL551A, OPL551-OC, OPL551-OCA
Totem Pole - Low 0.25/2.5 0.25/1.5
OPL560, OPL560A, OPL560-OCA
Totem Pole - High
0.09/0.55 0.09/0.36 N/A
OPL561, OPL561-OC, OPL561-OCA
Totem Pole - Low
OPL562, OPL562A, OPL562-OC, OPL562-OCA
Totem Pole - High
0.025/0.23 0.025/0.14
N/A
OPL563, OPL563-OC, OPL563-OCA
Totem Pole - Low
OC = Open Collector Output
RoHS
© TT electronics plc
General Note
TT Electronics reserves the right to make changes in product specicaon without
noce or liability. All informaon is subject to TT Electronics’ own data and is
considered accurate at me of going to print.
OPL530, OPL531, OPL535, OPL536, OPL550,
OPL551, OPL560, OPL561, OPL562, OPL563
Issue C 09/2016 Page 2
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.electronics.com
OPL530, OPL550, OPL560 Series
OPL535, OPL536 Series
Pin # Sensor
1 Ground
2 Output
3 V
CC
Pin # Sensor
1 Ground
2 Output
3 V
CC
Pin # Sensor
1 Ground
2 Output
3 Vcc
DIMENSIONS ARE IN:
[ MILLIMETERS]
INCHES
Pin # Sensor
1 Ground
2 Output
3 Vcc
DIMENSIONS ARE IN:
[ MILLIMETERS]
INCHES