www.deltaelectronicsindia.com
Warranty
9
Seller warrants this product, if used in accordance with all applicable
instructions, to be free from original defects in material and workmanship
within the warranty period. If the product has any failure problem within the
warranty period, Seller will repair or replace the product at its sole discretion
according to the failure situation.
This warranty does not apply to normal wear or to damage resulting from
improper installation, operation, usage, maintenance or irresistible force (i.e.
war, re, natural disaster, etc.), and this warranty also expressly excludes
all incidental and consequential damages. Maintenance service for a fee is
provided for any damage out of the warranty period. If any maintenance is
required, please directly contact the supplier or Seller.
WARNING:
The individual user should take care to determine prior to use
whether the environment and the load characteristic are suitable,
adequate or safe for the installation and the usage of this product.
The Quick Guide must be carefully followed. Seller makes no
representation or warranty as to the suitability or fitness of this
product for any specic application.
yy
The mains socket outlet that supplies the UPS shall be installed near the
UPS and shall be easily accessible.
yy
During the installation of this equipment it should be assured that the
sum of the leakage current of the UPS and the connected loads does
not exceed 3.5mA.
yy
Connection to any other type of receptacle other than a two-pole, three-
wire grounded receptacle may result in shock hazard as well as violate
local electrical codes.
yy
In the event of an emergency, press the ON/ OFF Button and disconnect
the power cord from the AC power supply to properly disable the UPS.
yy
Do not allow any liquid or any foreign object to enter the UPS. Do not
place beverages or any other liquid-containing vessels on or near the
unit.
yy
The unit is intended for installation in a controlled environment (tempera-
ture controlled, indoor area free of conductive contaminants). Avoid in-
stalling the UPS in any location where there is standing or running water,
or excessive humidity.
yy
Do not plug the UPS input into its own output.
yy
Do not attach a power strip or surge suppressor to the UPS.
yy
Do not attach non-computer-related items, such as medical equipment,
life-support equipment, microwave ovens, or vacuum cleaners to the
UPS.
yy
Do not dispose of battery (batteries) in a re as they may explode.
yy
A battery can present a risk of electrical shock and high short circuit cur-
rent. The following precautions should be observed when working on
batteries:
1. Remove watches, rings, or other metal objects from the hands.
2. Use tools with insulated handles.
3. Wear rubber gloves and boots.
4. Do not lay tools or metal parts on top of battery (batteries).
5. Disconnect charging source prior to connecting or disconnecting
the terminals of battery (batteries).
yy
Internal battery voltage is 12Vdc. Battery type is sealed, lead-acid, 6-cell
battery.
yy
Servicing of batteries should be performed or supervised by personnel
knowledgeable of batteries and the required precautions. Keep unau-
thorized personnel away from batteries.
yy
When replacing battery (batteries), replace with the same number and
type of sealed lead-acid battery (batteries).
yy
Do not open or mutilate the battery or batteries. Release electrolyte is
harmful to the skin and eyes. It may be toxic.
yy
Attention! Hazardous through electric shock. Even disconnection of this
unit from the mains, hazardous voltage still may be accessible through
supply from the battery (batteries). The battery supply should be there-
fore disconnected in the plus and minus pole at the connectors of the
battery (batteries) when maintenance or service work inside the UPS is
necessary.
yy
To reduce the risk of overheating the UPS, do not cover the UPS’s cool-
ing vents and avoid exposing the unit to direct sunlight or installing the
unit near heat emitting appliances such as heaters or furnaces.
yy
Unplug the UPS prior to cleaning and do not use liquid or spray deter-
gent.
Troubleshooting
7
Problem Possible Cause Solutions
LED doesn’t
illuminate
The UPS is not on.
Press the ON/ OFF Button again to
turn on the UPS.
Battery voltage is too
low.
Charge the battery (batteries) at
least 6 hours.
Battery fault. Replace the battery (batteries).
The UPS
always runs
in battery
mode.
The power cord
becomes loose.
Re-plug the power cord.
The fuse is damaged.
Replace the fuse. For how to
replace the fuse, please refer to
Operation
3
.
The UPS
continuously
beeps.
Please check the
Fault Code Table for
the details.
Please check the Fault Code Table
for the details.
Backup time
is too short.
Battery voltage
is too low.
Charge the battery (batteries) at
least 6 hours.
Overload.
Remove some unnecessary loads.
Before reconnecting equipment,
please verify that the load matches
the UPS capability specied in the
specs.
Battery defect. Replace the battery (batteries).
If any abnormal situations occur that are not listed above, please call for
service immediately.
Technical Specifications
8
Model 600VA 1000VA
Capacity 600VA/360W 1kVA/600W
Nominal
Input Voltage
230 Vac
Input Voltage Range 140~300 Vac
Output Voltage 230 Vac ± 10% (Bat. mode)
Transfer Time Typical 4 ~ 8 ms
Waveform Simulated Sine Wave
Battery Type & No. 12V/7Ah x 1 12V/7Ah x 2
Charging Time Typical 4 ~ 6 hours
Dimensions
(D x W x H)
279 x 101 x 142 mm 320 x 130 x 182 mm
Net Weight (kgs) 4.2 7.8
Humidity 0 - 90% RH @ 0 - 40°C (non-condensing)
Noise Level Less than 40dB
* Specications are subject to change without notice.
Copyright © 2022 by Delta Electronics Inc. All Rights Reserved. Changes
may be made periodically to the information in this Quick Guide without
obligation to notify any person of such revisions or changes.
No. : 501330210003 (QR)
Version : V 0.3
Release Date : 2022_12_07