"Ad
v
a
n
ced
Ce
r
a
m
ic
Solutio
n
s"
Date: 03/17/03 Page 1 of 4
Fi
g
ure 1 Fi
g
ure 2 Fi
g
ure 3
15191 Bledsoe St. • Sylmar CA 91342 • TEL 818.364.9800 FAX 818.364.6100
Tanceram® MLCs for Smoothing & Decoupling Applications
www.johansondielectrics.com
Historically, Tantalum capacitors have been used for smoothing and decoupling applications for
switching power supplies, DC/DC converters, LCD drivers and general digital circuits. As the
need grew for efficient power converters that operate at high frequencies, the design engineer
needed components that dissipated less heat. For high frequency applications, a Tanceram®‚ chip
capacitor is an excellent substitute for a Tantalum capacitor. Compared to a Tantalum capacitor,
a Tanceram��‚ chip capacitor has a low ESR and low ESL at high frequencies. As a result,
selecting a Tanceram®‚ capacitor with 1/2 to 1/10th the capacitance of a Tantalum will produce
an impedance that is more than an order of magnitude lower than the Tantalum capacitor over the
same high frequency range. The following example will compare the performance.
From 100 KHz to 70 MHz the typical 4.7uF Tanceram®‚ chip capacitor has a measured ESR from
.05 to .02 Ohms while a typical 10uF Tantalum capacitor ESR measures from 1.2 to 0.8 Ohms.
In this example, the Tanceram®‚ chip capacitor has a typical ESR that is 4% of the value of a
comparable Tantalum capacitor over the frequency range of 100 KHz to 70 MHz. (See Figure 1.)
A typical 4.7uF Tanceram®‚ chip capacitor has low impedance from 100 KHz to 70 MHz.
From Figure 2 the self-resonant frequency is approximately 3 MHz, for a remarkably low ESL of
600pH! Also, the lower impedance produces less heat in power conversion applications.
Figure 3 shows the temperature rise vs. ripple current. From the example capacitor values,
a Tanceram®‚ chip capacitor can handle approximately 3 times the ripple current to produce a
comparable temperature rise.
Often, substituting a Tanceram®‚ chip capacitor to replace a Tantalum capacitor will reduce the
circuit size and cost while providing superior performance. The Tantalum substitution guide on
page 2 was developed based on the principals discussed above.
Typical performance curves for popular Tanceram® parts can be found on page 3 & 4.
© 2003 Johanson Dielectrics, Inc. All rights reserved.
"Ad
v
a
n
ced
Ce
r
a
m
ic
Solutio
n
s"
Date: 03/17/03 Page 2 of 4
Tantalum Ca
p
acitor to X7R Dielectric Tanceram Re
p
lacement Guideline
Ca
p
acitance Value Case Size
Tantalum Tanceram 0603 0805 1206 1210 1812
1.0 uF 0.22 uF 25 V
2.2 uF 0.47 uF 16 V 50 V
4.7 uF 1.0 uF 10 V 25 V 50 V
10 uF 2.2 uF 16 V 25 V
22 uF 4.7 uF 16 V
47 uF 10 uF 10 V
Tantalum Ca
p
acitor to X5R Dielectric Tanceram Re
p
lacement Guideline
Ca
p
acitance Value Case Size
Tantalum Tanceram 0603 0805 1206 1210 1812
1.0 uF 0.22 uF 16 V
2.2 uF 0.47 uF 10 V
4.7 uF 1.0 uF 10 V
10 uF 2.2 uF 6.3 V 10 V
22 uF 4.7 uF 6.3 V 10 V
47 uF 10 uF 6.3 V 6.3 V 25 V 25 V
100 uF 22 uF 6.3 V 16 V
200 uF 47 uF 6.3 V
470 uF 100 uF 6.3 V
Tantalum Ca
p
acitor to Y5V Dielectric Tanceram Re
p
lacement Guideline
Ca
p
acitance Value Case Size
Tantalum Tanceram 0603 0805 1206 1210 1812
1.0 uF 0.47 uF 16 V 50 V
2.2 uF 1.0 uF 10 V 50 V
4.7 uF 2.2 uF 6.3 V 16 V 50 V
10 uF 4.7 uF 10 V 25 V 50 V
22 uF 10 uF 6.3 V 10 V 25 V
47 uF 22 uF 10 V 10 V
100 uF 47 uF 6.3 V 10 V
200 uF 100 uF 6.3 V 6.3 V
15191 Bledsoe St. • Sylmar CA 91342 • TEL 818.364.9800 FAX 818.364.6100
Tanceram® MLCs for Smoothing & Decoupling Applications
www.johansondielectrics.com
© 2003 Johanson Dielectrics, Inc. All rights reserved.