APPLICATION NOTE
AN-00895-17
XTR50011-D EVALUATION BOARD
By Laurent Martinez, X-REL Semiconductor
AN-00895-17 rev1A 2017-01-25
1 of 4
PROPRIETARY INFORMATION
www.x-relsemi.com
© 2017 X-REL Semiconductor
TABLE OF CONTENTS
Introduction .......................................................................................................................................... 2
XTR50011-D Evaluation Board BOM ..................................................................................................... 2
XTR50011-D Evaluation Board Features ............................................................................................... 2
XTR50011-D Evaluation Board Operation ............................................................................................. 4
Important Notice & Disclaimer ............................................................................................................. 4
Contact Us ............................................................................................................................................. 4
ABSTRACT
This application note describes how to use the XTR50011-D Evaluation Board. This covers XTR50011-D features and describes how to
evaluate them.
XTR50011-D EVALUATION BOARD
AN-00895-17 rev1A 2017-01-25
2 of 4
PROPRIETARY INFORMATION
www.x-relsemi.com
© 2017 X-REL Semiconductor
INTRODUCTION
The XTR50011-D Evaluation Board is a laboratory tool for measurement and design validation.
It is not expected to be used as a production tool.
It enables end user to test application at high temperature up to 200degC.
The Evaluation Board does not come equipped with a XTR50011-D device in the board socket.
A device must be procured and the socket populated by the end user for operation.
The board is metallic marked “11” in the bottom right corner for identification.
Note:
This document refer to the XTR50010 datasheet. Please review up to date version of this XTR50010 datasheet for any further product de-
tailed information.
XTR50011-D EVALUATION BOARD BOM
3 wires (PTFE rated at 250degC) to connect VCCA, VCCB and GND. Those 3 wires are labeled accordingly.
1uF capacitors X7R rated 125degC: 2pcs
100nF capacitors NPO rated 200degC: 2pcs
Jumper top set up OE XTR50011-D pin voltage: VCCA, VCCB or GND.
This jumper is made of metal wire to be connected to 2 single connector receptacles (Digikey Ref. ED90066-ND)
16 pin socket for the XTR50011-D built using single connector receptacles (Digikey Ref. ED90066-ND).
Ports A and B 7 bit channel single point connector to solder every individual signal for level translation through the XTR50011-D.
XTR50011-D EVALUATION BOARD FEATURES
The XTR50011-D Evaluation Board feature enables the end user to easily exercise each of the ports A and B and assess XTR50011 fea-
tures as part of its final design.
For further information about the XTR50011-D features and characteristics please refer to the XTR50010 datasheet.
The board is built from below schematic:
1
2
3
4
16
15
14
13
12
11
10
98
7
6
5
DIP16
XTR50011-D
A1
VCCA
A3
A2
A4
A5
OE
A6
B3
B2
VCCB
B1
GND
B6
B4
B5
A1
A2
A3
A4
A5
A6
B1
B2
B3
B4
B5
B6
1uF
GND
VCCA
VCCB
1uF
100nF 100nF
VCCA
VCCB
GND
OE
XTR50011-D Eval. Board