Ttape

1000A

Instruction for Use

A18506-00 04192022

Any information furnished by Laird Technologies, Inc. and its agents is believed to be accurate and reliable. All specifications are subject to change without notice. Responsibility for the use and application of Laird Technologies materials rests with

the end user. Laird Technologies makes no warranties as to the fitness, merchantability, suitability or non- infringement of any Laird Technologies materials or products for any specific or general uses. Laird Technologies shall not be liable for

incidental or consequential damages of any kind. All Laird Technologies products are sold pursuant to the Laird Technologies’ Terms and Conditions of sale in effect from time to time, a copy of which will be furnished upon request. © Copyright

2020 Laird Technologies, Inc. All Rights Reserved. Laird, Laird Technologies, the Laird Technologies Logo, and other marks are trademarks or registered trademarks of Laird Technologies, Inc. or an affiliate company thereof. Other product or service

names may be the property of third parties. Nothing herein provides a license under any Laird Technologies or any third party intellectual property rights.

Application method: For individual parts:

1. NOTE: Ttape 1000A is difficult to handle as a freestanding material so it is not recommended to try and remove

both liners before application.

2. Remove liner from one side of the pad. One liner should be consistently easier to remove so remove that liner first.

3. Align the pad on the mounting surface. Apply finger pressure across the entire surface of the pad to remove any

trapped air.

4. Allow at least 1 to 2 minutes dwell time to allow the pad to wet the surface of the component. During this dwell

time the adhesion improves. Once the material has “wetted” the surface it cannot be re-positioned.

5. Remove the top liner. It is not recommended to lift the liner manually as this can damage the part. The

second/top liner can be removed easily by using a piece of tape as a tab to lift an edge.

How to Remove for Rework:

Begin removal with plastic spatula, edge of tongue depressor, or other sharp-edged object that won’t damage underlying

component. Once an edge is lifted, material is highly cohesive and usually be rolled up on itself. Another piece of Ttape

can also be used to help lift material. Once Ttape is rolled off component, any remaining residue can be cleaned with

isopropyl alcohol and a clean lint-free rag.

Storage:

Material should be stored in a clean dry place (<70%RH) at a temperature between 4°C and 29°C.

Shelf Life:

12 months for date of shipment