© Semiconductor Components Industries, LLC, 2016
August, 2016 − Rev. 0
1 Publication Order Number:
EVBUM2485/D
NCP12510B65GEVB
65 W Notebook Off-line
Adaptor with NCP12510
Evaluation Board User
Manual
Description
This evaluation board user manual describes the
NCP12510B65GEVB board and its main parameters, i.e.
efficiency, no−load input power consumption, EMI
signature, transient responses, etc.
The evolution board is a flyback topology converter
which provides output voltage 19 Vdc for output nominal
current up to 3.5 A, therefore, the nominal output power is
65 W. Input voltage range is recommended from 90 Vac up
to 265 Vac.
The switching of the converter is ensured by the
NCP12510 – fixed−frequency current−mode PWM
controller switching at 65 kHz. The frequency foldback
down to 26 kHz is implemented for achievement the high
efficiency during light load conditions. The skip cycle and
low supply current of the controller ensures the very low
no−load input power consumption (standby power) of the
converter, which is less than 40 mW without indication LED
on output.
The controller is also equipped with a lot of protections.
The standard protection is over−current protection which
disables the switching after fault timer is elapsed. This
protection is activated when over−current or short−circuit
conditions appear. In the case of damage of some component
important for regulation, the controller is equipped with fast
over−voltage protection on OPP pin (pin 3) and VCC pin
(pin 5). The controller protects the whole converter against
overheating by an NTC thermistor connected to the OPP pin
(pin 3). The protection against high power capability of
converter at high line is over−power protection. It is based
on reducing the internal peak current setpoint depending on
input voltage value.
Key Features
• Excellent Standby Power Consumption
• High Efficiency
• High Robustness and High ESD Capabilities
• Wide Input Voltage Range (90 – 265 Vac)
• Low EMI Emissions
• Over−Current Protection
• Over−Temperature Protection
• Over−Voltage Protection
• Over−Power Protection
Table 1. GENERAL PARAMETERS
Device Applications Input Voltage
Nominal Output
Voltage / Current
Output
Power
V
OUT
Ripple
NCP12510 Notebook Adaptors, Ac – dc
converters for consumer electronics
90 – 265 Vac 19 Vdc / 3.5 A
4.5 A max limit
65 W < 20 mV @ no load
and min input voltage
Efficiency Standby Power
Operating
Temperature
Cooling Topology Board Size
~91% 20 mW @ 120 Vac
31 mW @ 230 Vac
0 – 50°C Passive cooling Flyback 111 x 48 x 21 mm
www.onsemi.com
EVAL BOARD USER’S MANUAL