DW4-6590B-R2
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 28, 2020
Page of 1 6
10-port multiband dualpol planar array antenna, 2x 814-894 and 8x
2300–2400 MHz, 65 | 90° HPBW, 2x RET
1 column for 814-894 and 4 columns for 2300-2400 MHz
Two internal RETs to control the antenna arrays
Integrated with a calibration board
Optimized for Software Defined Split 6 Sector applications
General Specifications
Antenna Type Sector
Band Multiband
Calibration Connector Interface N Female
Calibration Connector Quantity 1
Color Light gray
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage |Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN
RF Connector Interface 4.3-10 Female
RF Connector Location Bottom
RF Connector Quantity, high band 8
RF Connector Quantity, low band 2
RF Connector Quantity, total 10
Remote Electrical Tilt (RET) Information, General
RET Interface 8-pin DIN Female |RS-485 Male (input port, 2)
RET Interface, quantity 1 female |1 male
Dimensions
Width 350 mm|13.78 in
Length 1825 mm|71.85 in
Depth 209 mm|8.228 in
Column Spacing 58 mm|2.283 in
Electrical Specifications
DW4-6590B-R2
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 28, 2020
Page of 2 6
Operating Frequency Band 2300 – 2400 MHz |814 – 894 MHZ
Total Input Power, maximum 900 W @ 50 °C
Electrical Specifications, Soft Split
Beamwidth, Horizontal 33 °
CPR at Beampeak 18 dB
Front-to-Back Total Power at 180° ± 30° 30 dB
Remote Electrical Tilt (RET) Information, Electrical
Protocol 3GPP/AISG 2.0 (Single RET)
Power Consumption, idle state, maximum 1 W
Power Consumption, normal conditions, maximum 10 W
Input Voltage 10–30 Vdc
Internal RET High band (1) |Low band (1)
Beam Forming Weights