ZIGBIT 900MHZ WIRELESS MODULES
ATZB-X0-256-4-0-CN
DATASHEET
Features
• Compact size (38.5 x 20.0mm)
• High RX sensitivity (-103dBm)
• Outperforming link budget (up to +112dB)
• Up to +9.0dBm output power
• Very low power consumption:
• 8.7mA in RX mode
(1)
• 34.8mA in TX mode
(1)
• 0.6µA in sleep mode
(2)
• Ample memory resources (256KB In-System, Self-Programmable Flash memory,
4KB EEPROM, 16KB SRAM)
• Wide range of interfaces (both analog and digital)
• 4-wire SPI, TWI
• ISP, JTAG
• Two analog comparator input
• UART, USART
• Timer, PWM
• Four ADC lines
• External Clock Input, Internal Clock Output
• Up to 32 lines configurable as GPIO
• Preassigned Atmel
®
MAC address that can be used on end product
• Capability to use MAC address into the internal EEPROM
• IEEE
®
802.15.4 compliant Transceiver
• 900MHz ISM band
• Serial bootloader
• High Performance Low Power Atmel AVR
®
XMEGA
®
8- and 32-bit Microcontroller
• Rapid design-in with built-in Chip Antenna
• RF Test point using MS-147 RF connector
• Small physical footprint and low profile for optimum fit in very small application
boards
• Mesh networking capability
• Easy-to-use low cost development kit
• Single source of support for HW and SW
• Worldwide license-free operation
Notes: 1. MCU is in active state with 3V Supply, CPU clock @ 16MHz, RX RPC enabled (for RX current),
PHY_TX_PWR=0x0 (for TX current), all digital outputs pulled high.
2. Controller Sleep Mode: SLEEP_MODE_PWR_DOWN.
42268C−WIRELESS−02/2015
ATZB-X0-256-4-0-CN [ZigBit 900MHz Wireless Modules]
42268C−WIRELESS−02/2015
2
Table of Contents
1. Introduction ........................................................................................ 3
1.1 Summary ........................................................................................................... 3
1.2 Applications ....................................................................................................... 3
1.3 Abbreviations and Acronyms ............................................................................ 3
1.4 Related Documents ........................................................................................... 4
2. ZigBit Module Overview ..................................................................... 5
2.1 Overview ........................................................................................................... 5
3. Specifications ..................................................................................... 7
3.1 Electrical Characteristics ................................................................................... 7
3.1.1 Absolute Maximum Ratings ................................................................ 7
3.1.2 Power Supply ...................................................................................... 7
3.1.3 RF Characteristics .............................................................................. 8
3.1.4 ATxmega256A3U Microcontroller Characteristics .............................. 9
3.1.5 Module Interfaces Characteristics ....................................................... 9
3.2 Physical/environmental Characteristics and Outline ......................................... 9
3.3 Pin Configuration ............................................................................................. 10
3.4 Antenna Orientation Recommendation ........................................................... 11
3.5 Mounting Information ...................................................................................... 11
3.6 Soldering Profile .............................................................................................. 14
3.7 Antenna Reference Designs ........................................................................... 14
4. Schematics ...................................................................................... 15
4.1 Handling Instructions ....................................................................................... 20
4.2 General Recommendations ............................................................................ 20
5. Persistence Memory ........................................................................ 21
6. Ordering Information ........................................................................ 22
7. Agency Certifications ....................................................................... 23
7.1 United States (FCC) ........................................................................................ 23
7.2 Industry Canada (IC) Compliance Statements ................................................ 23
8. Revision History ............................................................................... 25