Additional CommScope Materials
Part Number Description
STRT-1 Removal tool for SA-ISO
SSH-M SnapStak Plus hanger for 14mm to 25mm cables
SSH-L SnapStak Plus hanger for 25.1mm to 36mm cables
SSH-XL SnapStak Plus hanger for 36.1mm to 51mm cables
Inches 2 3 41
Millimeters 20 30 40 50 60 70 80 90 100
SA-ISO
PIM Isolator
Bulletin 7841070 Rev. A | Page 1 of 1
CommScope Infrastructure Academy offers installation training.
Installation Instructions
1
2a 2b
3a
Position isolator over 3/4" hole in a cable
ladder or tower adapter and push down
until it snaps into place.
© 2019 CommScope Bulletin 7841070 Rev. A
Notice: CommScope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: CommScope no acepta ninguna obligación ni responsabilidad como resultado de prácticas incorrectas o peligrosas de instalación, inspección, mantenimiento o retiro.
Avis : CommScope décline toute responsabilité pour les conséquences de procédures d’installation, d’inspection, d’entretien ou de retrait incorrectes ou dangereuses.
Hinweis: CommScope lehnt jede Haftung oder Verantwortung für Schäden ab, die aufgrund unsachgemäßer Installation, Überprüfung, Wartung oder Demontage auftreten.
Atenção: A CommScope abdica do direito de toda responsabilidade pelos resultados de práticas inadequadas e sem segurança de instalação, inspeção, manutenção ou remoção.
Avvertenza: CommScope declina eventuali responsabilità derivanti dell’esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
CommScope
1100 CommScope Place SE P.O. Box 339, Hickory, NC 28603-0339
(828) 324-2200 (800) 982-1708
www.commscope.com
Customer Service 24 hours
North America: +1-800-255-1479 (toll free)
Any country: +1-779-435-6500
email: acicustomersupportcenter@commscope.com
Snap hanger
into isolator (2a).
Always alternate
hanger and
isolator to prevent
loose metal-to-
metal contact.
A maximum of
2 cable hangers
can be stacked
together as shown
(left, 2b).
Latches for snapping
into hole
Removal pads
The STRT-1 tool is
shown here (3b)
with proper removal
alignment on the
base pads of the
isolator.
3/4" hole for mounting
snap-in hangers
3b
To remove isolator(3a), use the STRT-1
tool or pliers and press base pads
together. Then pull away from the mount.