Installation and maintenance
condensing unit manual
OP-HJZM / HNXM / HRXM / LNYM / LRYM / LJHM
Manual
http://cc.danfoss.com
Manual
2 BC251686497767en-US0801
A: Model and bar code
B: Unit code and bar code
C: Serial number and bar code
D: Compressor voltage & Locked rotor amps &
Rated load amps
E: Fan voltage & Full load amps
F: Min. Circuit Ampacity
G: Max. Fuse size
H: Design pressure
I: Refrigerant
J: Oil type
K: Outdoor housing
L: Wiring diagram
0RGHO
6HULDO1XPEHU
&RPSUHVVRU
)DQ0RWRU
'HVLJQ3UHVVXUH
2LO7\SH32(
9)/$$
0&$$

+RXVLQJIRU2XWGRRUXVH
'DQIRVV&RGH
$
%
&
'
(
)
+
,
-
.
/
*
+-=08:*1
1
R404A/R134a/R507/
R448A/R449A/R452A
Label
L M N O
12" 26" 22" 22"
AIR FLOW
1 - Installation and maintenance of the
condensing unit must be carried out by qualied
personnel only. Follow these instructions and best
practices on refrigeration engineering during
installation, commissioning, maintenance and
servicing tasks.
2 - The condensing unit must only be used for
its designed purposes and within its scope of
application.
3 - Under all circumstances requirements must be
fullled.
4 - The condensing unit is delivered under
nitrogen gas pressure (14.5psi) and hence
it cannot be connected as it is; refer to the
“Installation” section for further details.
5 - The condensing unit must be handled with
caution in a vertical position (maximum oset
from the vertical: 15°).
IMPORTANT
Picture 1 : Minimum
mounting distances
Installation & Maintenance