Data sheet
''''DRIW-E16, 24 V AC/DC''''
Page 1/6
P/N
1101501322
EAN 4250184120308
2021/08/09
Illustrations
Dimensional drawing Wiring diagram
See enlarged drawings at the end of document
Product specification
The speed and V-belt monitor is used for monitoring the rotary movement (insufficient speed) of motor and V-belt driven shafts. Inductive
proximity switches are used for capturing the speed. Pulses are generated by the sensor without contact by means of driven control cams,
toothed wheels, segmented discs, metal signal flags or similar. The relay is activated when the operating voltage is applied. After start-up
bridging has finished, the monitoring function is started on the E1 and E2 terminals by means of the power contactor of the drive. When the
drive speed falls below the switch-off speed, the relay is deactivated. The fault message of the speed or V-belt monitor is reset by means of
the reset function und by switching off the operating voltage.
Data sheet
''''DRIW-E16, 24 V AC/DC''''
Page 2/6
P/N
1101501322
EAN 4250184120308
2021/08/09
Technical Data
Supply
Operating voltage 24 V AC/DC -10% ... +10%
Frequency range 50 ... 60 Hz
Duty cycle relative 100 %
Recovery time 400 ms
Inputs
Release time typical 85 ms
Outputs
Contacts 2 changeover contacts
Contact material AgNi
Switching voltage (max.) 250 V
Continuous Current 6 A
Switching frequency 1200 switching cycles/h
Mechanical life 1x10
7
switching cycles
Electrical life 1x10
5
switching cycles
Indicator green and red LED
Insulation coil - contact set
Nominal voltage of the power supply system 230 / 400 V AC
Overvoltage category III | II
Degree of pollution 2 | 2
Rated test voltage 4 kV | 2.5 kV
Type of insulation basic insulation | reinforced insulation
Housing
Dimensions
Dimension (W x H x D) 22.5 mm x 61.3 mm x 60 mm
Dimension (W x H x D) 0.886 in. x 2.413 in. x 2.362 in.
Weight 70 g
Mounting style Standard rail TH35
Mounting position any
Apposition without distance
Connection type Screw type terminal blocks