The R&S®ENV216 two-line V-network meets the

requirements of CISPR 16-1-2 and EN 55016-1-2

for V-networks with a simulated impedance of

(50µH +5Ω) || 50Ω in the frequency range from

9kHz to 30MHz as well as the ANSI C63.4 in the

frequency range from 150 kHz to 30 MHz. A female

connector with protective earth contacts is pro-

vided for connecting the EUT. Various models with

country-specific connector systems are available.

Owing to its compact design and low weight, the

R&S®ENV216 is ideal for frequently varying applications

and especially for on-site disturbance voltage measure-

ments on single-phase EUTs. Note that high leakage

currents are produced because of the standard design

of these V-networks. The networks should therefore be

connected to a low-impedance protective earth system. In

uncertain cases, an isolating transformer should be used.

In the case of AC supply operation in a range from

90 V to 240 V and 50 Hz to 60 Hz, the operating voltage

for the built-in logic circuit is obtained from the AC supply

direct. This covers all standard applications. If the EUT is

operated with low AC voltages or DC voltages up to 50 V,

the logic circuit is powered via an external plug-in power

supply that is supplied as standard.

Key facts

❙ Frequency range 9 kHz to 30 MHz

❙ Power-handling capacity up to 16 A, constant current

(country-speciﬁ c)

❙ Simulated impedance (50 µH + 5 Ω) || 50 Ω in line with

CISPR 16-1-2 Amd. 2:2006

❙ V-network in line with CISPR, EN, VDE, ANSI,

FCCPart15 and MIL-STD-461D, E and F

❙ Calibrated in line with CISPR 16-1-2

R&S®ENV216

Two-Line V-Network

At a glance