Application Note
R20AN0514EG0100 Rev.1.00 Page 1 of 7
Jun.1.20
RX72M Group
Renesas Starter Kit Sample Code (e
2
studio for CC-RX)
Introduction
Renesas Starter Kits (RSK+) are supplied as complete development systems for the selected
microcontroller. The kit includes an evaluation board, portable On-Chip Debugger, and a set of peripheral
sample code.
Target Device
RX72M Group
Development Environment
IDE: e
2
studio v7.8.0
Compiler: Renesas CC-RX v3.02.00
Hardware: Renesas Starter Kit+ for RX72M
Contents
1. Installation ............................................................................................................................... 2
2. Creating the Project Workspace .............................................................................................. 2
3. Opening the Sample Code and Source Files ........................................................................... 5
4. Source Code Functionality ....................................................................................................... 5
5. Website and Support ............................................................................................................... 6
Revision History .............................................................................................................................. 7
RX72M Group Renesas Starter Kit Sample Code (e
2
studio for CC-RX)
R20AN0514EG0100 Rev.1.00 Page 2 of 7
Jun.1.20
1. Installation
This section assumes that e
2
studio and the Renesas RXC toolchain are already installed.
Create a new folder, for example ‘C:\Renesas\Workspace\RSK\RSK+RSK72M’. Copy the application note
zip package ‘an-r20an0514eg0100-rx72m-rsk.zip’ downloaded from the website to this folder.
2. Creating the Project Workspace
Open e
2
studio by clicking the Windows Start button, select All Programs > Renesas Electronics e2studio >
e2 studio.
Select <Launch>.
In the ‘Toolchain Registry’ dialog select the ‘Renesas CCRX’ and ‘Renesas CCRX – v3.02.00’ checkboxes.
Click <Register>.
The ‘Information’ dialog below appears. Click <OK>.