Features Benefits
15kV Output Voltage
The new 960IPS bar provides an output of 15kV compared with the 10kV provided by
the original 929IPS bar. This 50% increase in power allows the 960IPS to operate at
greater distances (up to 600mm).
Low Voltage Wiring
The 960IPS is powered by 24V DC. The connection system is a standard industrial
M8 connector. This greatly simplifies installation; avoiding the need to route high
voltage cables from a remote high voltage power supply.
Adjustable Output
Performance can be optimised using the optional Hyperion BarMaster programmer or
SmartControl:
Adjustable balance allows fine control in sensitive applications.
Adjustable frequency allows the selection of the optimum frequency for the target
distance. For example, slower frequencies give better control over longer distances.
Adjustable voltage for improved performance.
Shockless Titanium Emitters
The Titanium emitter pins on the 960IPS are resistively coupled to the high voltage
supply. Independent research has shown titanium to be one of the very best materials
for emitter pins; with extremely low wear rates. The resistive coupling built into the bar
makes the pins shockless to touch, making it safe for operators to handle.
Dual Alarm Lines for Clean Pin and Fault
Alerts
The 960IPS adopts the advanced alarm system of the latest Hyperion products. Dual
alarm lines tell remote monitoring systems whether the ionising equipment needs
routine maintenance or whether there is a more serious system failure. The flexible
configuration of the alarm system, allows the alarm lines to be interfaced with PLCs,
buzzers and remote lamps.
IP66 Construction
IP66 construction allows the bar to be mounted in areas subject to wash-down or
where there is the likelihood of spillages. IP66 provides total dust protection from high-
pressure water jets from any direction.
Please note that should the bar become wet it must be thoroughly dried before being
powered-up.
Clean Pins Alert
The local LED is solid green to indicate that the bar is on, working correctly and giving
good ionisation performance.
A red flashing LED shows that Meech’s Ion Current Monitoring technology has
detected that the bar needs cleaning.
Fault Alert
Constant red illumination indicates that a fault has been detected on the high voltage
outputs.
Slimlined End Cap Design
The end caps of the 960IPS are slimline, resulting in no dead space. The bar offers
full-length ionisation, with the effective length the same as the overall length of the
bar.
Divider
The 960IPS needs to be able to operate in dirty, factory environments. To minimise
the impact of contamination and maximise the interval between cleaning, the bar
features a divider between the positive and negative emitters. This divider, first
introduced by Meech on the 976 bar, over 15 years ago, is an essential feature of the
bar.
T-Slot
Mounting of the bar is made easy using the T-Slot at the rear of the bar. The M4 T-
Bolts used are the same as used on other Meech pulsed DC bars.