Form code: TA 251
Revision: 2016-12
www.dnvgl.com
Page 1 of 2
© DNV GL 2014. DNV GL and the Horizon Graphic are trademarks of DNV GL AS.
Certificate No:
TAK00001H8
This is to certify:
That the Adhesive
with type designation(s)
SPABOND 340 LV HT - Series
Issued to
Gurit (UK) Ltd.
Newport, Isle Of Wight, United Kingdom
is found to comply with
DNV GL class programme DNVGL-CP-0086 – Type approval – Adhesive systems
Application :
Bonding of epoxy and/or polyester laminates.
Issued at Hamburg on 2019-01-03
This Certificate is valid until 2024-01-02.
DNV GL local station: Hamburg Materials & Welding
Approval Engineer: Guido Michalek
for DNV GL
Thorsten Lohmann
Head of Section
This Certificate is subject to terms and conditions overleaf. Any significant change in design or construction may render this Certificate invalid.
The validity date relates to the Type Approval Certificate and not to the approval of equipment/systems installed.
Digitally Signed By: Wildhagen, Christian
Signing Date: 2019-01-28
Location: DNV GL Hamburg, Germany
, on behalf of
Job Id: 262.1-029586-1
Certificate No: TAK00001H8
Form code: TA 251
Revision: 2016-12
www.dnvgl.com
Page 2 of 2
Product description
Two component epoxy resin system.
Approved variants
Epoxy resin SP 340LV with following hardener
- HT Fast hardener
- HT Slow hardener
- HT Extra-slow hardener
Type Approval documentation
- Technical Data Sheet
- Material Safety Data Sheet
- Test Report No.7069 issued by the DNV GL approved (Approval No. AOSS0000DHK) testing laboratory
of Gurit Newport (UK).
- Approval of Manufacturer (AMPM0000023) valid until 2021-02-28.
- Quality assurance/control documentation
Material Properties
Properties
SP 340LV
HT Fast
hardener
HT Slow
hardener
HT Extra
slow hardener
Unit
Density at 21°C
1.13
1.10
1.11
1.05
g/cm³
Viscosity at 23°C
240 - 300
130 - 170
140 - 180
140 - 180
P
Limitation
The adhesive complies with the applicable requirements of DNV GL and is compatible to the adherends.
Any significant changes in design and / or quality of the material will render the approval invalid.
Assessed production site
Gurit (UK) Ltd.
St. Cross Business Park
PO30 5WU Newport, Isle of Wight
United Kingdom
Periodical assessment
A production site with a valid Approval of Manufacturer (AoM) certificate for material in question is
exempted from the obligation concerning retention and renewal assessments.
For manufacturer without a valid AoM a periodical assessment after 2.5 years and at renewal after 5
years is required.
Remarks
This certificate supersedes the approval WP 1040009 HH.
END OF CERTIFICATE