UMFT602X Module Datasheet

Version 1.0

Document Reference No.: FT_001390 Clearance No.: FTDI#518

Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or

reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its

documentation are supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or

implied. Future Technology Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or

failure of this product. Your statutory rights are not affected. This product or any variant of it is not intended for use in any medical

appliance, device or system in which the failure of the product might reasonably be expected to result in personal injury. This

document provides preliminary information that may be subject to change without notice. No freedom to use patents or other

intellectual property rights is implied by the publication of this document. Future Technology Devices International Ltd, Unit 1, 2

Seaward Place, Centurion Business Park, Glasgow G41 1HH United Kingdom. Scotland Registered Company Number: SC136640

Future

Technology

Devices

International Ltd

UMFT602A/

UMFT602X

The UMFT602A/X is an evaluation/development

module with either HSMC or FMC (LPC)

connectors for interfacing FTDI’s FT602 32bit

FIFO bus to USB 3.1 GEN 1 USB video class

(UVC) bridge IC with external hardware. The

UMFT602A/X allows for bridging a FIFO bus to a

USB3.0 host and evaluating the functionality of

the FT602.

As a daughter card, the UMFT602A/X must work

with a FIFO master board which has either a

HSMC or FMC connector. There are 2 models

which provide different FIFO bus interfaces with

32bit data width.

The modules are designed such that they can

plug into most FPGA development platforms

supplied by vendors such as Xilinx or Altera.

Refer to Ordering Information for module

options.

The UMFT602A/X supports 2 parallel slave FIFO

bus protocols (Multi-Channel FIFO / 245

Synchronous FIFO) with a data “burst” rate of up

to 400MB/s. For a full list of the FT602’s features

refer to the FT602 datasheet.

The UMFT602A/X module has the following features:

 Supports USB 3.1 GEN 1 Super Speed

(5Gbps)/USB 2.0 High Speed (480Mbps)

transfer

 UVC 1.1, Raw YUV422

 Up to 4 video input channels. One I2C bus

master interface for video source device

configuration

 Supports multi voltage I/O: 1.8V, 2.5V and 3.3V

 High speed connector for FIFO bus : FMC(Field

Programmable Mezzanine Card) or HSMC (High

Speed Mezzanine Card)

 FMC connector is compatible with most Xilinx

FPGA reference design boards

 HSMC is compatible with most Altera FPGA

reference design boards

 Multi powered options: external DC powered,

BUS powered, FMC/HSMC powered

 Hardware Reset

 Micro-USB3.0 receptacle