Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or

reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its

documentation are supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or

implied. Bridgetek Pte Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product.

Your statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or

system in which the failure of the product might reasonably be expected to result in personal injury. This document provides

preliminary information that may be subject to change without notice. No freedom to use patents or other intellectual property

rights is implied by the publication of this document. Bridgetek Pte Ltd, 178 Paya Lebar Road, #07-03, Singapore 409030.

Singapore Registered Company Number: 201542387H

CleO50 Module Datasheet

Version 1.1

Document Reference No.: BRT_000205 Clearance No.: BRT#045

Bridgetek Pte Ltd

Datasheet

CleO50 Module

1 Introduction

CleO50 is a smart TFT display shield for Arduino

and MikroBUS. It includes a 5.0 inch 800x480 pixell

TFT LCD panel with resistive touch, PWM audio

output with in-built speaker amplifier for better

audio quality. For the convenience of user, speaker

cable with 1X4 socket to 2 pin wire ended and 1X2

socket is provided. Users can use their own

speaker.

These smart TFT display shields can be easily

programmed by almost anyone to give

professional looking HMI / GUI's with no prior

knowledge of complex graphics programming or

mathematics.

1.1 Features

CleO50 utilises the Bridgetek FT900 low power MCU

to bridge between the Arduino and fast interface

accessories such as MikroBUS, camera and SD Card

input. For a full list of the FT900’s features refer to

the FT90X datasheet. In addition, CleO50 has the

following features:

 Support landscape and portrait modes

 In built Bridgetek FT812 embedded video

engine (EVE) graphic controller

 Anti-aliased graphics throughout for much finer

image quality with no "jaggies"

 Ready to use LCD module with resistive touch

in panel mountable bezel

 USB DFU port for firmware updates

 In built 8M Byte Eflash memory

 PWM audio supported and in built speaker

amplifier

 Support MikroBUS interface

 Support Micro SD card

 Support camera interface

 Support I2S interface

 Support CAN bus

 Support RTC function

 Designed as Arduino and NerO shield

 Compatible with Bridgetek CleO-RIO, CleO-

Camera and CleO-Speaker

 CE and FCC certified

Note: MikroBus interface is created by MikroElektronika is an

open standard anyone can implement in their design. Please

visit MikroE for more detail

CleO50 Module Datasheet

Version 1.1

Document Reference No.: BRT_000205 Clearance No.: BRT#045

2 Ordering Information

Part No.

Description

CleO50A

CleO50 module, with FPC/FFC 40 LCD connector, 5.0 inch TFT LCD display

panel preinstalled with resistive touch. Black bezel.

CleO-RIO1

Arduino Shield for users to stack Arduino board on bottom of CleO50.

CleO-CAM1

A camera plug-in module for CleO50.

CleO-SPK1

A speaker enclosure with connecting wires to CleO50.

3 Program Support

Demo applications are provided for CleO50 modules by Bridgetek. Visit Bridgetek’s website

http://brtchip.com/m-cleo50/ for more information.