Rev. 0.3 10/14 Copyright © 2014 by Silicon Laboratories C8051F36x-DK
C8051F36x-DK
C8051F36x DEVELOPMENT KIT USER’S GUIDE
1. Relevant Devices
The C8051F360 Developm ent Kit is intended as a deve lopm ent plat fo rm for the micr ocontrollers in th e C8051F36x
MCU family.
Notes:
The target board included in this kit is provided with a pre-soldered C8051F360 MCU (LQFP48 package).
Code developed on the C8051F360 can be easily ported to the other members of this MCU family.
Refer to the C8051F36x data sheet for the differences between the members of this MCU family.
The C8051F36x family of devices are code-compatible with the C8051F330/1/2/3/4/5 family of devices.
2. Kit Contents
The C8051F36x-DK Development Kit contains the following items:
C8051F360 Target Board
C8051Fxxx Development Kit Quick-Start Guide
AC/DC Power Adapter
USB Debug Adapter (USB to Debug Interface)
USB Cable
CD-ROM
3. Hardware Setup Using a USB Debug Adapter
The target board is connected to a PC running the Simplicity Studio via the USB Debug Adapter as shown in
Figure 1.
1.
Co
nnect the USB Debug Adapter to the DEBUG connector on the target board with the 10-pin ribbon
cable.
2.
Co
nnect one end of the USB cable to the USB connector on the USB Debug Adapter
.
3
.
Co
nnect the other end of the USB cable to a USB Port on the PC.
4.
Co
nnect the AC/DC Power Adapter to power jack P2 on th e target bo ar d.
Notes:
Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
Remove power from the target board before removin g the ribbon cable from the target board. Connecting
or disconnecting the cable when the devices have power can damage the device and /or the USB Debug
Adapter.
C8051F36x-DK
2 Rev. 0.3
Figure 1. Hardware Setup using a USB Debug Adapter
PC
USB
Cable
USB Debug Adapter
AC/DC
Adapter
Target Board
P1
P3.0 P3.1 RESET
P4
P2
DEBUG
J9
U3
F360
U1
USB
ACTIVE
D5
PWR
POWER
D3
D4
P3
SILICON LABS
www.silabs.com
J14
+3VD
J13
P2.5
PORT_1
J3
PORT_2
J4
PORT_3
J5
PORT_4
J6
PORT_0
J2
J8
J12
SW3.0
TX
P3.3_LED
RX
CTS
RTS
P3.2_LED
SW3.1
P3.0
P0.1
P3.3
P0.2
P3.5
P3.4
P3.2
P3.1
J1
P1_PWR
SER_PWR
VBUS
REG_IN
REG_IN
REG_IN
J15
J16
J10J11
C8051F360 TB
R10
Silicon Laboratories
USB DEBUG ADAPTER
Run
StopPower