Worm Gear Mixer Drives Features
• Delroyd Unique Worm & Gear Design
- Operation with multiple tooth contact
- Shockless power delivery
- Quiet operation (meets OHSA sound standards 76 to 80 Dba)
- Provides economical & efcient at low speeds
• Available Single reductions from 5:1 through 70:1 for output
speeds down to 25 rpm (standard 1750 rpm motors)
• Available Double reductions from 15:1 to 350:1 to provide outputs
as low as 5 rpm
• Note: Gearing efciency is quite different from mixing efciency.
Mixing efciency is inuenced by gearing efciency
• Delroyd worm gear drives are engineered to withstand up to
300% momentary peak overloads and shock loads
• Delroyd mixer drives offer a minimum service factor of 1.25
• In Delroyd units, heavy-duty tapered roller bearings (B-I0 life
of over 10,000 hours on the worm shaft; B-I0 life of 100,000
hours on low speed shaft) minimize shaft vibration and sensitivity
to shaft deection. This eliminates the need for hollow quill
construction and lowers the overall cost of the mixer/agitator.
• The centrifugally cast phosphorous bronze gear mates with a
hardened, ground and polished steel worm. As the drive operates,
the bronze gear conforms and work-hardens to the contour of the
worm. This is responsible for the saying that “Delroyd worm gears
wear in, not wear out.”
• Standard drywell construction provides positive protection against
leakage of lubricants. There’s no danger of product contamination.
• Standard Delroyd units range from 3 through 14-inch center
distances, and horsepower from .132 to 265 HP.
• Drives with even larger center distances and greater horsepower
are available.
Drywell
Standard on
3” to 14”
Increased
Bearing Span
Fitting for Grease
Lubrication of Bearings
Heavy Duty
Tapered Roller Bearing
Oversized
Output Shaft
Cooling F
Standard
Design Features and Internal Construction
Call our Toll-Free Application Hotline: 800-432-0121
P-7560-DWG 3/19
www.delroyd.com
2221 Niagra Falls Boulevard
Niagra Falls, NY 14302 - USA
716-298-4100