

ACT88430

Advanced PMU for Microcontrollers and

Solid State Drive A

lications

Data Sheet Rev. 3.0, Nov. 11, 2019 | Subject to change without notice

1 of 51

www.qorvo.com

BENEFITS and FEATURES

 Wide input voltage range

 Vin = 2.7V to 5.5V

 Complete integrated power solution

 One 4A DC/DC Step-Down (Buck) Regulator

 Three 2.5A DC/DC Step-Down (Buck)

Regulators

 One 800mA LDO

 Two 200mA LDOs

 Space Savings

 Fully integrated

 High Fsw =2.25MHz or 1.125MHz

 Integrated sequencing

 Easy system level design

 Configurable sequencing

 Seamless sequencing with external supplies

 Buck 1 Bypass Mode for 3.3V system level

compliance

 Highly configurable

 uP interface for status reporting and controllability

 Programmable Reset and Power Good GPIO’s

 Flexible Sequencing Options

 I

C Interface – 1MHz

APPLICATIONS

 Computer Vision

 Microcontroller Applications

 Solid-State Drives

 FPGA

 Video Processor

GENERAL DESCRIPTION

The ACT88430 PMIC is an integrated ActivePMU

power management unit. It is designed to power a wide

range of processors, including video processors,

FPGA’s, peripherals, microcontrollers, and solid-state

drive applications. It is highly flexible and can be

reconfigured via I

C for multiple applications without the

need for PCB changes. The low external component

count and high configurability significantly speeds time

to market. Examples of configurable options include

output voltage, startup time, slew rate, system level

sequencing, switching frequency, sleep modes, operat-

ing modes etc. ACT88430 is programmed at the factory

with default configuration. These settings can be

optimized for a specific design through the I

C interface.

The ACT88430 comes in several default configuration.

Contact the factory for specific default configurations.

The core of the device includes four DC/DC step down

converters using integrated power FETs, three

low-dropout regulators (LDOs), and an optional load

switch. Each DC/DC regulator switches at 2.25MHz,

requiring only three small components for operation.

The LDOs only require small ceramic capacitors. All are

highly configurable via the I

C interface.

The ACT88430 PMIC is available in a 5 x 5 mm 40 pin

QFN package.