Datasheet
R01DS0330EJ0100 Rev.1.00 Page 1 of 98
Aug 30, 2019
RX23E-A Group
Renesas MCUs
Features
■ 32-bit RXv2 CPU core
Max. operating frequency: 32 MHz
Capable of 64 DMIPS in operation at 32 MHz
Enhanced DSP: 32-bit multiply-accumulate and 16-bit multiply-
subtract instructions supported
Built-in FPU: 32-bit single-precision floating point (compliant to
IEEE754)
Divider (fastest instruction execution takes two CPU clock cycles)
Fast interrupt
CISC Harvard architecture with 5-stage pipeline
Variable-length instructions, ultra-compact code
On-chip debugging circuit
Memory protection unit (MPU) supported
■ Low power design and architecture
Operation from a single 1.8-V to 5.5-V supply
Three low power consumption modes
Low power timer (LPT) that operates during the software standby state
■ On-chip flash memory for code
Read cycle of 31.25 ns in 32-MHz operation
No waiting time when the CPU is reading at full speed
128-Kbyte to 256-Kbyte capacities
On-board or off-board user programming
Programmable at 1.8 V
For instructions and operands
■ On-chip data flash memory
8 Kbytes (1,000,000 program/erase cycles (typ.))
BGO (Background Operation)
■ On-chip SRAM, no wait states
16- to 32-Kbyte size capacities
■ Data transfer functions
DMAC: Incorporates four channels
DTC: Four transfer modes
■ ELC
Module operation can be initiated by event signals without using
interrupts.
Linked operation between modules is possible while the CPU is
sleeping.
■ Reset and supply management
Seven types of reset, including the power-on reset (POR)
Low voltage detection (LVD) with voltage settings
■ Clock functions
Main clock oscillator frequency: 1 MHz to 20 MHz
External clock input frequency: Up to 20 MHz
PLL circuit input: 4 MHz to 8 MHz
On-chip low- and high-speed oscillators, dedicated on-chip low-speed
oscillator for the IWDT
Clock frequency accuracy measurement circuit (CAC)
■ Independent watchdog timer
15-kHz on-chip oscillator produces a dedicated clock signal to drive
IWDT operation.
■ Useful functions for IEC60730 compliance
Self-diagnostic and disconnect detection assistance functions for the A/
D converter, clock frequency accuracy measurement circuit,
independent watchdog timer, RAM test assistance functions using the
DOC, etc.
■ MPC
Input/output functions selectable from multiple pins
■ Up to eight communication functions
CAN (one channel) compliant to ISO11898-1:
Transfer at up to 1 Mbps
SCI with many useful functions (up to four channels),
asynchronous mode, clock synchronous mode, smart card interface,
reduction of errors in communications using the bit rate modulation
function
I
2
C bus interface: Transfer at up to 400 kbps, capable of SMBus
operation (one channel)
RSPI (one channel): Transfer at up to 16 Mbps
■ Up to 12 extended-function timers
16-bit MTU: input capture, output compare, complementary PWM
output, phase counting mode (six channels)
8-bit TMR (four channels)
16-bit compare-match timers (two channels)
■ Analog functions
Two 24-bit delta-sigma A/D converters
A/D converter with up to 23-bit effective resolution (gain = 1, output
data rate = 7.6 SPS)
High-precision programmable gain instrumentation amplifier,
30 nV
RMS
(gain = 128, output data rate = 7.6 SPS)
Rail-to-rail programmable gain instrumentation amplifier
(gain = 1 to 128)
Two operating modes and programmable data rates,
Normal mode: Output data rate of 7.6 SPS to 15625 SPS,
Low power mode: Output data rate of 1.9 SPS to 3906 SPS
Offset drift 10 nV/°C (gain = 128)
Gain drift 1 ppm/°C (gain = 1 (PGA), gain = 2 to 128)
Up to six differential inputs, 11 single-ended inputs
Fourth-order sinc filter
Simultaneous 50 Hz/60 Hz rejection (output data rate = 10, 54 SPS)
Offset error and gain error calibration
Inter-unit A/D conversion synchronized start
Delta-sigma A/D input disconnect detection assist
Delta-sigma A/D reference voltage external input
Voltage reference
output voltage: 2.5 V ±0.1%,
temperature drift: 4 ppm/°C, output current: ±10 mA
Excitation current sources: Up to four,
Output current: 50 μA to 1000 μA, current matching: ±0.2%, drift
matching: 5 ppm/°C
Bias voltage generator
output voltage: (AVCC0 + AVSS0)/2
Temperature sensor: Accuracy ±5°C
Low-side switch: 10 Ω on-resistance
Low power-supply-voltage detectors
Delta-sigma A/D input voltage fault detectors
Delta-sigma A/D reference voltage fault detectors and disconnect
detectors
Excitation current source disconnect detectors
■ 12-bit A/D converter
Capable of conversion within 1.4 μs
Six channels
Sampling time can be set for each channel
Self-diagnostic function and analog input disconnect detection
assistance function
■ General I/O ports
5-V tolerant, open drain, input pull-up, switching of driving capacity
■ Operating temperature range
–40°C to +85°C
–40°C to +105°C
■ Applications
General industrial and consumer equipment
PLQP0048KB-B 7 × 7 mm, 0.5 mm pitch
PWQN0040KC-A 6 × 6 mm, 0.5 mm pitch
32-MHz, 32-bit RX MCUs with up to 256-KB flash memory,
2 low-noise and low-drift 24-bit delta-sigma A/D converters,
rail-to-rail programmable gain instrumentation amplifiers,
a low-drift voltage reference, and on-chip excitation current sources
R01DS0330EJ0100
Rev.1.00
Aug 30, 2019