Instruction manual

Rack Mount Support Angle KRB1-PWX SUPPORT ANGLE

This product is a rack mount support angle designed specifically for Kikusui PWX Series Regulated DC Power Supplies

It can also be used with the Kikusui KRC Series and KRO Series. It is not compatible with products made by other companies.

Be sure to use the support angles in pairs.

Components

Check that all parts are included and that they are not damaged. If any of the parts are damaged or missing, contact your

Kikusui agent or distributor.

Attaching the support angles to KRC Series racks

Attach the support angle to the rack using the M5 screws and slide nuts.

Attachment is the same also as JIS millimeter racks and EIA inch racks.

Attaching the support angles to KRO Series racks

Attach the support angle to the rack using the M5 screws, nuts and washers.

No. Parts Code Description Quantity

1 B9-000-169 Rack mount support angle PWX 1U 2

2 M9-000-009 Rack mount support angle M5 screw set ( Screw 1 pc., Slide nut 1 pc. ) 4

3 M4-100-005 Rack mount support angle nut (M5) 4

4 M5-100-005 Rack mount support angle washer (M5) 4

Mark “ż´

The nuts and washers are not used.

M5 screw (2 locations)

Support angle

Slide nut

)DFHWKH³ż´VLGHRIWKHVOLGHQXW

toward you, and insert into the rack.

Turn the slide nut to the right 90

degrees, check that it is hooked,

and then tighten with a screw.

■ When attaching the power supply

to a JIS millimeter rack

■ When attaching the power supply

to an EIA inch rack

M5 screw (2 locations)

M5 nut (4 locations)

M5 washer (4 locations)

Support angle

M5 screw (2 locations)

M5 nut (4 locations)

M5 washer (4 locations)

Support angle

The slide nuts are not used.

KIKUSUI ELECTRONICS CORP.

1-1-3 Higashiyamata, Tsuzuki-ku, Yokohama, 224-0023, Japan

Tel: +81-45-482-6353

Fax: +81-45-482-6261

http://www.kikusui.co.jp/en

Website