Command List

KIKUSUI Electronics Corp. PCR-MA Interface Manual

*CLS

Clears all event registers including the status byte, event status, and error queue.

*ESE

Sets the event status enable register that is counted by the event summary bit (ESB) of the

status byte.

*ESR

Queries the event status register.

*IDN

Queries the model name, serial number, and rmware version of the PCR-MA.

*LRN

Queries the command that can restore the current panel settings.

*OPC

Sets the OPC bit (bit 0) of the event status register when all the commands in standby have

been completed.

*OPT

Queries the optional interface board that are installed in the PCR-MA.

*PSC

Sets whether to clear the event status enable register and the service request enable

*RCL

Reads the contents stored in memory.

*RST

Resets a portion of the product settings.

*SAV

Stores the current panel settings to memory

*SRE

Sets the service request enable register.

Command List

*STB

Queries the contents of the status byte register and the MSS (master summary status)

message.

*TRG

Trigger command.

*TST

Executes a self-test.

*WAI

Prevents the PCR-MA from executing subsequent commands until all operations in standby

are complete.

ABOR

Aborts operations such as change and measurement in all trigger subsystem (TRANSient/

ACQuire).

ABOR:ACQ

Aborts operations such as execute in ACQuire trigger subsystem.

ABOR:TRAN

Aborts the setting change trigger function.

DISP:AMM

Sets the measured value displayed on the lower numeric display.

INIT:ACQ

Clears the present valid measurement data and starts a new measurement.

INIT:CONT:ACQ

Sets the auto continue mode of the ACQuire subsystem.

INIT:TRAN

Starts the setting change (TRANsient) trigger function.

LXI:IDEN

Turns the identify display on or off.

FETC:<meas-item>/ MEAS:<meas-item>

Queries the scalar measurement data specied with <meas-item>.

OUTP

Turns the output on and off.