1. Initial Setup and Demo
Start by connecting the two probes to the 2 channels and connect each to the square wave
generator on the front of the scope.
View the square waves by pushing “AUTO”. After a few seconds you should see this:
Single Wave (F1)
Multiple Wave (F2)
Rising Edge (F3)
Falling Edge (F4)
When the “AUTO” Menu is up just after auto has completed you will see options for looking at
multiple waves, single wave, rising edge, or falling edge. That is how the AUTO function works.
Whenever you get into trouble or don’t know what you are looking at you can hit AUTO and it
will usually find the meaningful signal.
If you still have trouble after that you can go to “SAVE” -> from the “MENU” soft key press it
and select FACTORY (F7) . Once FACTORY is pressed this will reload all factory settings and
you will recover from whatever settings were altered.