15
Clamping element MPAF(1x)
16
Screw(1x)
17
Screw(2x)
18
Clamping element CPA(2x)
Fig. 10
4 Mounting
4.1 Wall mounting
4.1.1 Check positions of the mountings
Mountings are preassembled depending on the configuration.
CPX modules: counting direction from the end plate[V]
MPA modules: orientation from the mounting points of the adapter plate[W]
Fig. 11
1. Check positions of the preassembled mountings and correct if required.
2. Assemble by step 3, 4, 5, 6 or 7 depending on the mounting:
3. Positions of mounting2 with CPX modules (plastic)
Number of modules Mounting between the modules
2 and 3 5 and 6 8 and 9
1…2 –
3 •
1)
4…5 •
6…8 • •
9…10 • • •
1) This mounting is not required in combination with MPAL valve terminals.
Tab. 3
4. Positions of mounting3 with CPX modules (metal)
Number of modules Mounting to the modules
2 3 4 6 7
1…3 –
4 •
5…6 •
7 •
8 • •
9…10 • •
Tab. 4
5.
Positions of the mounting5 with MPALVI valve terminal ³ 200 mm
– every 130 mm
6.
Positions of the mounting6 with MPAF valve terminal ³ 300 mm
– every 250 mm on subbase
7.
Positions of the mounting8/aJ with MPAS valve terminal ³280 mm
– a mounting every 130 mm:
– 8 on MPAS proportional pressure regulator or
– aJ on MPAS intermediate supply
With MPAS valve terminals size 14 in
• horizontal or vertical suspended position from mounting point [V] mount
a MPAS intermediate supply after every third module.
• horizontal recumbent position from mounting point [W] mount a MPAS
intermediate supply after every second module.
SG2: total length of valve terminal £ 430 mm
SG1: total length of valve terminal > 430 mm
4.1.2 Assemble mountings
4.1.2.1 Mounting[2] on CPX modules (plastic)
Fig. 12
1. Press mounting2 inclined into the back of the modules[A].
2. Tilt mounting2 until it catches.
3. Install additional mounting2 opposite.
4.1.2.2 Mounting[3] on CPX modules (metal)
For CPX modules (metal) without system supply, the mounting3 can be
assembled on both sides of the module.
Fig. 13
1. Place mounting3 on the module[B].
2. Tighten4 screws. When screwing in again, use the threads already present.
Tightening torque: 1.5Nm ± 10 %
4.1.2.3 Mounting[5] on MPAL-VI modules
Fig. 14
1. Press mounting5 inclined into the back of the modules[C].
2. Tilt mounting5 until it catches.