QUICK START GUIDE
SAM R34 Xplained Pro Evaluation Kit
(DM320111)
Get Started
Hardware Setup
• SAM R34 Xplained Pro Evaluation Kit (DM320111)
• Micro USB cable
• LoRaWAN
TM
gateway
Software Setup
• TeraTerm (terminal emulator)
• Network server with gateway and end device
registered
• LoRaWAN gateway (online)
1
www.microchip.com/DM320111
Link Up
Connect to Network Server Using Pre-Programmed
Serial Network Provision Application
1. Open TeraTerm. Choose the EDBG Virtual COM port
and enabled local echo.
2. The default settings for the UART interface are 115200 bps,
8-bits, no parity, one Stop bit and no ow control.
3. A menu with two types of join options will appear on
TeraTerm. Choose the appropriate join mechanism
based on the join mechanism (OTAA/ABP) chosen
while registering the end device.
4. Enter the appropriate EUI/Address/Keys (LoRaWAN
Network Provisioning Information) based on the join
mechanism chosen. Provisioning information can be
either uppercase 0-F or lower case 0-f values without
spaces or special characters in between subsequent
values.
5. Once all the network parameters for the expected
join type are entered, conrm the network parameters
entered.
6. Choose the demo application by selecting the appropri-
ate band based on the region of operation.
• The preprogrammed end device application
supports 7 bands of LoRaWAN regional
specication, AU915, AS923, EU868, IND865,
JPN923, KR920, NA915.
• After choosing the band, join request is sent to the
Gateway-network server/join server.
3
Plug In
Connect
your board (EDBG USB) to your PC with
a micro USB cable. Your personal computer will
recognize the board as a Virtual COM port. Open the
virtual COM port in a terminal emulator running on
the PC and send/receive the data.
2