TYPE
PRODUCT SPECIFICATION
NUMBER
GS-12-309
TITLE PAGE REVISION
1 of 10 B
AUTHORIZED BY DATE
HDMI CONNECTOR
PLUG & RECEPTACLE
Leif Shen 28/10/’04
CLASSIFICATION
RELEASED
This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI Electronics. No part of the information shown on this document may be used in
any way without the written consent of FCI Electronics.
Form E-3005
Rev A 02/12/01
V20603
GS-01-001
1 OBJECTIVE
This specification defines the performance requirements for HDMI connector.
2.0 GENERAL
This document is composed of the following sections
PARAGRAPHS TITLE
1.0 OBJECTIVE
2.0 GENERAL
3.0 MATERIAL
4.0 ELECTRICAL CHARACTERISTICS
5.0 MECHANICAL CHARACTERISTICS
6.0 ENVIRONMENTAL PERFORMANCE
7.0 RECOMMENDED TEMPERATURE PROFILE
8.0 TEST SEQUENCE
PDM: Rev:B Released .STATUS: Printed: Sep 05, 2007
TYPE
PRODUCT SPECIFICATION
NUMBER
GS-12-309
TITLE PAGE REVISION
2 of 10 B
AUTHORIZED BY DATE
HDMI CONNECTOR
PLUG & RECEPTACLE
Leif Shen 28/10/’04
CLASSIFICATION
RELEASED
This document is the property of and embodies CONFIDENTIAL and PROPRIETARY information of FCI Electronics. No part of the information shown on this document may be used in
any way without the written consent of FCI Electronics.
Form E-3005
Rev A 02/12/01
V20603
GS-01-001
3.0 MATERIAL
The material for each component shall be as specified herein, or equivalent.
3.1
Housing: High temperature grass filled resin UL94-V0, color black.
The housing will withdraw exposure to 250 ℃ peak temperature for 3-6 seconds in a IR reflow oven.
3.2 Contact : copper alloy
3.3 Shell : Copper alloy
3.4 Finish
Contact area: 30u” Au or 15u” GXT under plated 1,27 microns Ni
Solder area: 1.27 microns Sn under plated 1.27 microns Ni.
Shell: 2.54 microns Ni.
4.0 ELECTRICAL CHARACTERISTICS
4.1 Contact Resistance
<Test Condition>
Mated connectors,
Contact : measure by dry circuit, 20 mV maximum, 10mA.
Shell : measured by open circuit, 5 V maximum ,100mA.
(ANSI/EIA-364-06A-83)
<Requirement>
Contact : 30 mΩ maximum.
Shell : 50 mΩ maximum.
4.2 Dielectric Strength
<Test Condition>
Unmated connectors, apply 500 Volts AC (RMS.) between adjacent terminal or ground.
(ANSI/EIA 364-20, Method 301)
Mated connector, apply 300 Volts AC (RMS.) between adjacent terminal and ground.
<Requirement>
No Breakdown
4.3 Insulation Resistance
<Test Condition 1>
Unmated connectors, apply 500 Volts DC between adjacent terminal or ground.
(ANSI/EIA 364-21, Method 302)
<Requirement 1>
100 MΩ minimum (unmated)
PDM: Rev:B Released .STATUS: Printed: Sep 05, 2007