EPOXY RESIN 25068-38-6Epoxy Resin:--reaction Product Of
Bisphenol A And Epichlorohydrin
(refer To Epichlorohydrin)
40 - 60
37244-96-5Nepheline And Nepheline Syenite 20 - 40
TITANIUM DIOXIDE 13463-67-7Titanium Dioxide 2.5 - 10
2.5 - 10Other components below reportable levels
14807-96-6Talc 1 - 2.5
4. First-aid measures
Move to fresh air. Call a physician if symptoms develop or persist.
Inhalation
Remove contaminated clothing immediately and wash skin with soap and water. In case of
eczema or other skin disorders: Seek medical attention and take along these instructions. Wash
contaminated clothing before reuse.
Skin contact
Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists.
Eye contact
Rinse mouth. Get medical attention if symptoms occur.
Ingestion
Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred
vision. Skin irritation. May cause redness and pain. May cause an allergic skin reaction. Dermatitis.
Rash.
Most important
symptoms/effects, acute and
delayed
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves. Wash contaminated clothing before reuse.
General information
5. Fire-fighting measures
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Suitable extinguishing media
Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
During fire, gases hazardous to health may be formed.
Specific hazards arising from
the chemical
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Special protective equipment
and precautions for firefighters
Move containers from fire area if you can do so without risk.
Fire fighting
equipment/instructions
Use standard firefighting procedures and consider the hazards of other involved materials.
Specific methods
No unusual fire or explosion hazards noted.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear
appropriate protective equipment and clothing during clean-up. Avoid breathing mist/vapors. Do
not touch damaged containers or spilled material unless wearing appropriate protective clothing.
Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be
contained. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product
recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid discharge into drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Avoid breathing mist/vapors. Avoid contact with eyes, skin, and clothing. Avoid prolonged
exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe
good industrial hygiene practices.
Precautions for safe handling
Store in tightly closed container. Store away from incompatible materials (see Section 10 of the
SDS).
Conditions for safe storage,
including any incompatibilities
2 / 7
Material name: DEVCON® Epoxy Coat™ 7000 Non-VOC Resin
0160 Version #: 02 Revision date: 04-29-2020 Issue date: 05-28-2019
SDS US