Junction and Storage Temperature Range
Operating Temperature Range
5000
300
°C
°C
P
PPM
I
PP
P
M(AV)
I
FSM
V
F
T
J , TSTG
T
OP
Peak Pulse Power Dissipation with a 10/1000µs waveform (Fig.1)(Note1), (Note 2)
Peak Pulse Current with a 10/1000µs waveform.(Note1,Fig.3)
Power Dissipation on Infinite Heat Sink at T=75°C
Peak Forward Surge Current, 8.3ms Single Half Sine Wave (Note 3)
Maximum Instantaneous Forward Voltage at 25A for Unidirectional Only (Note 4)
See Next Table
6.5
3.5/5.0
-55 to +150
-40 to +125
W
A
W
A
V
Parameter Symbol Value
Unit
The 5.0SMDJ series is designed specifically to protect sensitive electronic
equipment from voltage transients induced by lightning and other transient
voltage events
For surface mounted applications in order to optimize board space
Low leakage
Uni and Bidirectional unit
Glass passivated junction
Low inductance
Excellent clamping capability
5000W Peak power capability at 10 × 1000µs waveform Repetition
rate (duty cycle):0.01%
Fast response time: typically less than 1.0ps from 0 Volts to V min
Typical I
High Temperature soldering: 260°C/40 seconds at terminals
= 0.1% ×V
Matte tin lead–free Plated
��� Halogen free and RoHS compliant
Typical failure mode is short from over-specified voltage or current
Whisker test is conducted based on JEDEC JESD201A per its table 4a and 4c
IEC-61000-4-2 ESD 15kV(Air), 8kV (Contact)
ESD protection of data lines in accordance with IEC 61000-4-2 (IEC801-2)
EFT protection of data lines in accordance with IEC 61000-4-4 (IEC801-4)
5.0SMDJ Series
TVS devices are ideal for the protection of I/O interfaces, V bus
and other vulnerable circuits used in Telecom, Computer, Industrial
and Consumer electronic applications.
Maximum Ratings (TA=25℃ unless otherwise noted)
Features
1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25°C per Fig.2.
2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minutes maximum.
4. V
F < 3.5V for VBR < 200V and VF< 6.5V for VBR > 201V.
Description
Uni-directional Bi-directional
Applications
Notes:
ROHS
Revision March 1,2022
Surface Mount Transient Voltage Suppressors (TVS)
www.unsemi.com.tw
11 To 440V 5000W
www.unsemi.com.tw
Cathode
Bi-directional
Anode
Uni-direction
For technical questions, contact: tech@unsemi.com.tw
Specifications are subject to change without notice.
Please refer to www.unsemi.com.tw for current information.
1/7
Functional Diagram