Application Note
R01AN6046EJ0130 Rev.1.30 Page 1 of 4
August 31, 22
RX Family
Renesas ZMOD4410, ZMOD4450 and ZMOD4510 Sensor Control Module
Firmware Integration Technology
Introduction
This application note explains the sensor control modules for ZMOD4410&ZMOD4450&ZMOD4510 (Digital
Gas Sensors) using Firmware Integration Technology (FIT).
This control module acquires the sensor data using the I2C bus control FIT module (IIC FIT Module). And
calculate environmental gas value for ZMOD4410, ZMOD4450 and ZMOD4510.
Hereinafter, the modules described in this application note is abbreviated as following,
- The sensor control module for ZMOD4410, ZMOD4450 and ZMOD 4510: ZMOD4XXX FIT module
The detail descriptions include “Overview”, “API Information” and “ZMOD4XXX API Functions” of this FIT
module are described in application note “Renesas Sensor Control Modules Firmware Integration
Technology (R01AN5892)”.
Please refer to “Renesas Sensor Control Modules Firmware Integration Technology (R01AN5892)” for using
this FIT module.
Target Device
• Sensors:
Renesas Electronics Digital Gas Senser ZMOD4410 (ZMOD4410 Indoor Air Quality
Platform), ZMOD4450 (ZMOD4450 Refrigeration Air Quality Sensor Platform) and
ZMOD4510 (ZMOD4510 Outdoor Air Quality Platform)
• RX Family MCUs:
MCUs supported the following IIC FIT module
I2C Bus Interface (RIIC) Module (RIIC FIT Module)
Simple I2C Module (SCI_IIC FIT Module) using Serial Communication Interface (SCI)
• Operation confirmed MCU:
RX65N (RIIC FIT Module, SCI_IIC FIT Module)
When using this application note with other Renesas MCUs, careful evaluation is recommended after making
modifications to comply with the alternate MCU.
Target Compiler
• Renesas Electronics C/C++ Compiler Package for RX Family
RX Family Renesas ZMOD4410, ZMOD4450 and ZMOD4510 Sensor Control Module Firmware Integration
Technology
R01AN6046EJ0130 Rev.1.30 Page 2 of 4
August 31, 22
Contents
Reference Documents ...................................................................................................................... 3
Revision History ................................................................................................................................ 4
General Precautions in the Handling of Microprocessing Unit and Microcontroller Unit Products .... 5
Notice ................................................................................................................................................ 6