Introduction
This manual covers the items required for maintaining the Mitsubishi Electric CNC M800/M80/E80 Series.
Supported models are as follows:
Abbreviations in this manual are as follows:
Read this manual thoroughly and understand the product's functions and performance before starting to use.
The unit names, cable names and various specifications are subject to change without notice. Please confirm these before
placing an order.
Be sure to keep this manual always at hand.
The following screens described in this manual are the screens for Mitsubishi Electric's display unit.
If the display unit you are using is not manufactured by Mitsubishi, please contact the machine tool builder.
CAUTION
For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by the
machine tool builder (MTB) takes precedence over this manual.
Items not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all the applicable functions are included. Some of them, however,
may not be available for your NC system. Refer to the specifications issued by the machine tool builder before
use.
Refer to the manuals issued by the machine manufacturer for each machine tool explanation.
Some screens and functions may differ depending on the NC system (or its version), and some functions may
not be possible. Please confirm the specifications before use.
To protect the availability, integrity and confidentiality of the NC system against cyber-attacks including unau-
thorized access, denial-of-service (Dos) (*1) attack, and computer virus from external sources via a network,
take security measures such as firewall, VPN, and anti-virus software.
(*1) Denial-of-service (Dos) refers to a type of cyber-attack that disrupts services by overloading the system or
by exploiting a vulnerability of the system.
Mitsubishi Electric assumes no responsibility for any problems caused to the NC system by any type of cyber-
attacks including DoS attack, unauthorized access and computer virus.
In this manual, the following abbreviations might be used.
MTB: Machine tool builder
Also refer to the manuals on "Manual List" as necessary.
Supported models Abbreviations in this manual
M800W Series M850W, M830W
M800S Series M850S, M830S
M80W Series M80W
M80 Series M80 TypeA, M80 TypeB
E80 Series E80 TypeA, E80 TypeB
Abbreviations Supported models
M800, M800 Series M800W Series/M800S Series
M80, M80 Series M80W Series/M80 Series
M800/M80, M800/M80 Series M800W Series/M800S Series/M80W Series/M80 Series
M8, M8 Series M800W Series/M800S Series/M80W Series/M80 Series/E80 Series