Jonard Tools Distributors Display

Instruction Manual

Thank you for being a Jonard Tools distributor and partnering with us on this branded

display. We simplified the building process by creating this step by step manual to guide

you during the installation process. We have included a breakdown of how the products

should be displayed for optimal visualization and space efficiency. Please contact us with

anything you need and we look forward to working with you.

DR-3 - TRIANGLE DISPLAY

PARTS INCLUDED

NOTE: The 2 large gridwalls need to have the horizontal bars on the inside of the triangle and the short gridwall is to have the

vertical bars on the outside of the triangle.

1. Remove items from packaging and make sure you have all items listed in PARTS INCLUDED.

2. Install wheels on base. This requires a 1/2” open end wrench and be sure to tighten wheels.

3. Place gridwall on base, and (using the 14 zipties) connect the gridwalls together.

• There should be 4 zipties in the back (one on top, one on the bottom and 2 in the middle).

• Squeeze the zipties together and pull (Use the Flush Cut Pliers to remove excess piece).

• On the front facing gridwall, below the top plate, tie 6 zipties, (one on each top corner, one on each bottom

corner & one in the middle of each). Do not tighten up corners yet.

ITEM QUANTITY

Hang Tags (TDR-5)* 40

Triangular Base with center plate (already assembled) 1

Wheels 3

NOTE: Ensure zipties are facing inward as they can be sharp after cutting.