Thank you for purchasing the KDE2315XF Brushless Motor Series upgrade for your DJI™ Phantom®. Please follow the instructions for

proper installation and flight control; and enjoy the enhanced performance and efficiency of the new power system.

Installation of the KDE2315XF Brushless Motor Series begins with removal of the upper-

case of the Phantom® body. For the DJI Phantom® 2, removal is simple via the use of

standard 1.5 mm and 2.0 mm hex wrenches. For the Phantom® 3, removal requires TORX

wrenches available at many hardware stores or online, in the T6 and T8 size specification.

Additional plastic locking-tabs are found around the case, so releasing these will allow for

removal of the upper case (and disconnection of the compass/GPS sensor).

Remove the original motors (use the 2.0 mm hex wrench

to unscrew the stock M3 socket-head cap screws),

exposing the motor mount. For the Phantom® 3 series,

four plastic tabs are molded into the mount and are not-

required. Simply remove or bend the tabs flush to the

motor mount with thumb-pressure, providing proper

clearance for the KDE2315XF motor case.

Install the KDE2315XF Brushless Motors with the

original M3 socket head cap screws, making sure

to install into the M3 x ф16/19 thread-pattern

machined into the motors for simple bolt-in fit.

Install the KDE2315XF DJI M6 Propeller Adapters

(for the self-tightening 9450 propellers) to the

motors with the included M3 x 5 mm button

head socket head cap screws.

Install the appropriate thread edition (RH and LH

edition) according to the image on the left.

Please double-check to make sure this is correct.

The KDE2315XF Brushless Motor power leads can be cut to length

and soldered to the existing DJI™ ESC board. The wires are color-

coded (black/red/blue) to provide simple installation to the ESC,

described in more detail on the following pages.

RH MARKING