Your advantages
– IP65 protection for use on the shopoor
– Simple test plan control
– Automated measurement runs
– High linearity thanks to high-end pneumo-
electronic transducer
– Very fast measurement cycles
High-precision, semi-automatic measurement runs
Gageline SG100, SG200 and SG500
The SG100 – SG500 measuring systems allow for
measurement of outer or inner diameters of different
types of cylindrical workpieces.
Characteristics measured
– Diameters on different levels
– Zero backlash
– Dynamic diameter measurement (prole evaluation)
– Matching tolerance of two workpieces
– Conicity
High-precision, semi-automatic measurement runs
Gageline SG100, SG200 and SG500
System components
– Evaluation unit (measurement computer
Sirius and Tolaris Premium software)
– Linear unit with associated electronics
– Pneumo-electronic transducer TPE200
– Pneumatic gaging component
(air spindles and air ring gages)
– Setting master
System features
– Available measuring systems: SG100 for inner
diameters, SG200 for outer diameters and
SG500 for combined inner/outer measurements
– Scanning or incremental measurement
on different levels
– Synchronous recording of measured values and
positon in Z- thanks to CANopen motion controller
– Emergency stop button
– Crash protection system for the gaging tool
– Easy access to pneumatic and electronic
connections for maintenance purposes
– Optional: dynamic measurement
(rotating workpiece)
Technical data
Total measuring stroke (linear unit) 200 mm*
Measuring stroke 100 mm*
Inner or outer diameter 1 – 25 mm
Measuring range 5 – 40 µm
Repeatability 0.05 µm (6S)
Max. number of measuring levels 127
Measurement speed e.g. 2 sec./cm
(depends on the selected
system conguration)
* larger workpiece dimensions on demand
SG100 for measurement of inner diameters SG200 for measurement of outer diameters
DB_SG100-SG200-SG500_en 04.04.2017 Copyright ©JENOPTIK Industrial Metr ology Germany GmbH. All rights reserved. Subject to change without notice. Photos may show options and are not legally binding.
JENOPTIK Industrial Metrology Germany GmbH
Alte Tuttlinger Strasse 20 | 78056 Villingen-Schwenningen
Germany | Phone +49 7720 602-0 | Fax +49 7720 602-444
metrology@jenoptik.com | www.jenoptik.com