Temperature 15 - 30°C (59 - 86°F)
Relative Humidity 20 - 90%
Application:
Four mils (.004") can be applied on a vertical plane without sags in one cross coat using
standard type pressure spray guns. (Example: DeVilbiss MBC gun, FF nozzle and #765
air cap). Use an atomization pressure of 75 pounds per square inch to 90 pounds per
square inch and enough pressure on the pot or container to force the material to the gun.
Airless spray can also be used such as Graco #205-904 with a 163-618 insert and a 28:1
ratio pump. To enable the film to knit properly, spraying should be at room temperature
of 60°F or higher. Only water should be used for cleaning equipment and for thinning the
material if required.
These application guidelines represent PPG’s best advice for usage in standard
conditions. Some parameters will be influenced by environmental conditions, equipment
settings, and other variables.
14 square meters/liter at 100 microns dry film (150 square feet/gallon at 4 mils dry film)
Recommended dry film thickness; 100 microns (4 mils)
Equipment:
PPG A Blue is compatible with most forms of spray equipment. See Application section
for details.
Equipment Cleaning:
Flush spray equipment ONLY with water.