Http://www. jisemi.com ESD0402V05CS
ESD0402V05CS
BIDIRECTIONAL TVS DIODE
DESCRIPTION
This device is an ultra low capacitance ESD product designed to
protect very high speed data interfaces.ESD0402V05CS has a
typical capacitance of only 0.15pf (I/O to GND), and it can be
used to meet the ESD immunity requirements of IEC61000-4-2
(15KV air, 8KV contact discharge).
FEATURES
ESD protection for high speed data lines to IEC61000-4-2.
ESD contact discharge typical 8KV, max 15KV.
ESD air discharge typical 15KV, max 25KV.
Surface mount.
Extremely low capacitance.
Very low leakage current.
Fast response time.
Bi-directional ESD protection.
Lead free solder termination.
The best ESD protection for high frequency, low voltage
applications.
APPLICATIONS
High Definition Multi-Media Interface (HDMI).
Digital Visual Interface (DVI).
Display Port Interface (DP).
Unified Display Interface (UDI).
Mobile Display Digital Interface (MDDI).
Gigabit Ethernet.
USB2.0 and USB3.0.
IEEE1394 interface.
Caution
This component is designed for signal line protection only,
Not intended to be used under bias, not for application with a
power line.
Schematic Diagram
Http://www. jisemi.com ESD0402V05CS
ESD0402V05CS
DEVICE CHARACTERISTICS
Absolute Maximum Ratings
Parameter
Symbol
Value
Unit
Maximum Contact discharge voltage Per IEC61000-4-2
—
15KV
V
Maximum Air discharge voltage Per IEC61000-4-2
—
25 KV
V
Maximum Operating temperature
TOPER
-40 to +90
°C
Maximum Storage temperature
TSTG
-55 to +125
°C
Maximum lead temperature for soldering during 10s
TL
260
°C
ELECTRICAL CHARACTERISTICS
(TA=25
O
C)
Note: 1 Trigger and clamping voltage are measured per IEC 61000-4-2, 8KV contact discharge method.
2 After reliability tests such as high temp storage, temp cycles, continuous ESD strike etc, the maximum leakage current is less than 10uA.
ESD CLAMPING TEST
Parameter
Symbol
Test Conditions
Min
Typ
Max
Units
Rated Voltage
R
—
—
—
5
V
Trigger voltage
T
IEC61000-4-2 8KV contact discharge
—
350
—
V
Clamping voltage
C
IEC61000-4-2 8KV contact discharge
—
35
—
V
Leakage current
II
DC 5V shall be applied on component
—
0.10
uA
Capacitance
CP
R
=0V,f=1MHz
—
0.15
pF