TRAP Transmitter
DS-TRAPTX-1
Description
A rugged Remote Transmitter which can be used with many of the RF Solutions
receivers to generate a Remote Control System.
The Transmitter may be user configured to transmit “Continually” whilst a switch is
pressed or transmit briefly only when a switch is pressed or released “State Change”
The TRAP transmitter can be set to request and Acknowledge back from the receiver
which it displays on the LED.
• Rugged RF Transmitter Handset
• Supplied “Ready to Go”
• 1 - 16 Switch Versions
• 868 / 918MHz FM Technology
• Max ERP +22dBm
• Range up to 2Km
• Waterproof IP65
• Powered from 3 x AAA Batteries
• LED Acknowledge from Receiver
• Continuous or State Change Transmit
• Compatible with RF Solutions FM
Receivers
• Rugged Protective OverBoot
• CE Compliant
Intended Applications
• Industrial Systems
• Pumps, Barriers
• Conveyors, machinery etc
• General Remote Switching
FM Hand Held Transmitter
TRAP Transmitter
Part Numbers
Disclaimer:
Whilst the information in this document is believed to be correct at the time of issue, RF Solutions Ltd does not accept any liability whatsoever for
its accuracy, adequacy or completeness. No express or implied warranty or representation is given relating to the information contained in this docu-
ment. RF Solutions Ltd reserves the right to make changes and improvements to the product(s) described herein without notice. Buyers and other
users should determine for themselves the suitability of any such information or products for their own particular requirements or specification(s).
RF Solutions Ltd shall not be liable for any loss or damage caused as a result of user’s own determination of how to deploy or use R F Solutions Ltd’s
products. Use of RF Solutions Ltd products or components in life support and/or safety applications is not authorised except with express written
approval. No licences are created, implicitly or otherwise, under any of RF Solutions Ltd’s intellectual property rights. Liability for loss or damage
resulting or caused by reliance on the information contained herein or from the use of the product (including liability resul ting from negligence or
where RF Solutions Ltd was aware of the possibility of such loss or damage arising) is excluded. This will not operate to lim it or restrict QuasarUK
Ltd’s liability for death or personal injury resulting from its negligence.
RF Solutions Ltd. Recycling Notice
Meets the following EC Directives: DO NOT Discard with normal waste, please
recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/EU Specifies certain
limits for hazardous substances.
WEEE Directive 2012/19/EU Waste electrical & electronic equipment. This
product must be disposed of through a licensed WEEE collection point. RF
Solutions Ltd., fulfils its WEEE obligations by membership of an approved
compliance scheme, environment agency registration number WEE/JB0104WV.
Waste Batteries and Accumulators
Directive 2006/66/EC
Where batteries are fitted, before
recycling the product, the batteries must
be removed and disposed of at a licensed
collection point.
RF Solutions battery producer number:
BPRN00060.
Part Number Description
FIREFLY -TX-IPKIT
’O’ Ring, Seals
Transmitter to IP68
Transmitters come with Lanyard
Transmitter
Part Number
1 Switch TRAP-8T1
2 Switch TRAP-8T2
4 Switch TRAP-8T4
16 Switch
(8Sw+Shift Key)
TRAP-8T16
Custom Branding
To create a customised transmitter can be a simple procedure!
Please contact Sales for further info.
Technical specifications
Transmitters: TRAP-Transmitter
Enclosure Rating: Standard IP65 (upgradeable to IP67)
Battery Life: 2 years @ approx. 50 1/2second presses p/day
Dimensions: 90 x 54 x 27 mm
Electrical Characteristics Min Typical Max Units
Supply Voltage 3.3 4.5 6 V
Frequency 869.500
MHz
FSK Deviation 868MHz 60
KHz
RF Output Power (ERP) - 15.5 22 dBm