SA818 MANUAL

Key operation:

1 key SET

Press it to setting mode, the data on LED nixie tube will be flickering, you can change it by key UP or

DOWN; Press key SET again, the item flickering will shift. If the item flickering is the last one, it will quit

setting mode.

2 key UP

When in setting mode, pressing key UP will increase the flickering value.

3 key DOWN

When in setting mode, pressing key DOWN will decrease the flickering value. Otherwise it will move

down the light LED.

4 key PTT

Pressing it will make the module into sending mode, when loosen the module into receiving mode.

5 Dial switch

When sending mode, switch to HIGH will send with high power, switch to LOW will send with low

power.

Set TX frequency

After power on, the LED close to “TXF” is on, indicates that LED nixie tube is displaying TX

frequency. Press key SET, the highest order of frequency will flicker, and can be changed by key UP or

DOWN. Press key SET to set the next order.

Set bandwidth

Press key DOWN, the LED close to “BW” is on, indicates that LED nixie tube is displaying

bandwidth, pressing key SET to setting mode and press key DOWN to change bandwidth.

Set RX subaudio.

Press key DOWN, the two LEDS close to “RXF” and “CTCS” are light up, it indicates that LED nixie

tube is displaying receiving subaudio. Press key SET to change receiving subaudio. If the LED nixie tube

display “00”, it means that no subaudio in receiving mode. If display “tcs”, it means that receiving subaudio

is analog, and if display “cds”, it means that receiving subaudio is digital.

Set volume

Press key DOWN, the LED close to “VOL” is on, press key SET to setting mode, and can be changed

by key UP or DOWN.

Set SQ

Press key DOWN, the LED close to “SQ” is on, press key SET to setting mode, and can be changed

by key UP or DOWN.

Set TX subaudio.

Press key DOWN, the two LEDS close “TXF” and “CTCS” are on, indicates that LED nixie tube is

displaying sending subaudio. Press key SET to change sending subaudio. If the LED nixie tube display “00”,

it means that no subaudio in sending mode. If display “tcs”, it means that sending subaudio is analog, and if

display “cds”, it means that sending subaudio is digital.

Set RX frequency

Press key DOWN, the LED close to “RXF” is on, indicates that LED nixie tube is displaying RX

frequency. Press key SET, the highest order of frequency will flickering, and can be changed by key UP or

DOWN.

Press key SET to set the next order.

Press key UP, it will start to scan frequency and subaudio, the frequency displayed on the LED nixie

tube will increase quickly and check the module whether receive the frequency and the subaudio, it will stop

when there is any signal or press key DOWN.