www.netmodule.com 8/7/2017 © NetModule AG | Errors reserved
NB1600 Overview
1
Status LED
Status indicator.
- blinking: The device is busy due to startup, software
or configuration update.
- on: The device is ready.
2
USB
USB 2.0 host port
3
Ethernet
Connect your router by using the Ethernet 1 port with
your computer to start the configuration. Your router is
configured as a DHCP server by default and has the IP
address 192.168.1.1. Open this IP in your browser to
reach the WEB-GUI.
4
LTE/UMTS
SMA female connectors for MIMO LTE or UMTS
antennas. Mobile 1 is the main, Mobile 2 the auxiliary
port.
5
WLAN
SMA female connectors for MIMO WLAN antennas.
WLAN 1 is the main port, WLAN 2 is the auxiliary port.
www.netmodule.com 8/7/2017 © NetModule AG | Errors reserved
6
GNSS
SMA female connector for GNSS antenna.
7
Power
The router can be powered with two external sources
(redundancy) with the nominal input voltages 12
VDC
,
24
VDC
and 48
VDC
.
Power supply 1: Pins 1 (GND) and 2 (+)
Power supply 2: Pins 3 (GND) and 4 (+)
8
Reset button
Reset button, press at least 3 seconds for reboot and at
least 10 seconds for a factory reset. The start of the
factory reset is confirmed by all LEDs lighting up for a
second. The button must be released then again.
9
SIM cover
Removing the SIM cover: Loosen the screw, remove it
and then remove the cover.
Please close the cover again after inserting the SIM card.
10
SIM holder
Slot for 1 Mini SIM (2FF).
The card holder can be opened by sliding it carefully in
the direction of antenna connectors and lift it up.
Then insert the SIM card with the chip facing to the back.
Close the holder again, and shift it back until it’s locked.
Please close the SIM cover after inserting the SIM card
and tighten the screw again.